20 Most Recent
2001 Hyundai Tiburon - Page 4 Questions & Answers
Fly wheel bolts keep coming lose
this happens when the flywheel is out of balance. Check that the mount area is clean and free of burrs on the crank shaft. Ensure that the threads in the crank shaft are burr free. ensure that if a dowel is used to locate the flywheel that it is in place . Use the fly wheel bolts once on;y. Use a low strength loc-tite compound on the bolt threads and tighten to specified tension (normally around 90-100ft/lbs.) use a tension wrench for this.. Next pay attention to the clutch pressure plate and that it is being held in place by the correct bolts . Small shanks that act as dowels to locate the plate exactly in position. Use locating dowels if there is holes in the flywheel for them . clamp a flat bar to thye engine flange and place it at the circumference of the flywheel and turn the engine over and see if it hits the bar in one spot or is the same distance away all the way around . Adjust the space till there is virtually no clearance under the bar. Then place the bar on the face of the flywheel and see if the flywheel is wobbling against the bar .You can use a dial indicator for these to teats .
2001 tiburon won't start
Or maybe a draw on the battery, meaning something is on like a glove box lite or trunk lite. Alternator is suspect too
HELP SPEEDO PROBLEM
Remove instrument cluster and sublet for inspection and/or repair at speedo shop.
Check engine light
code p1124 refers to long term fuel trim--additive-mixture too lean===causes --HO2s---fuel pressure--fuel system---mechanical fault---ECM
My starter bolt keeps comming undone and my
Your problem may be from not positioning the starter correctly in the hole on assembly. Make sure that the face of the starter is in the bell housing hole all the way and is not at an angle when tightened up. Use new spring washers under the nuts or heads of the bolts and tension to around 60 ft/lbs
Not finding what you are looking for?