20 Most Recent 2001 Hyundai Elantra - Page 8 Questions & Answers

The transmission input shaft may be binding on the clutch disc splines-because the transmission may be tilted down too much. Keep the transmission at same level and tilt as the engine, then pull straight back until the input shaft clears the clutch disc and pressure plate. If everything is removed from the transaxle, it should slide out all the way.

No do yourself a favour and fit a genuine BOSCH exchange unit ---bet you a pound to a penny this will cure the problem

Most likely a bad motor and/or regulator assembly.

check at the rear of your throttle and the rear of the inlet manifold .with a small bit of paper.

check for vacuum leaks in the small rubber hoses.

check the other fuses.