Top 20 2000 Hyundai Elantra - Page 8 Questions & Answers

It might be the flywheel make sure there are no oil leaks and clutch isn't contaminated does the gearbox select gears ok when it starts to slip before you re-bleed it?

Tail light switch is stuck or bad, or there is a short in the wiring. the switch is on the brake pedal further up on the rod.

i first check to see if you have a master power control switch at the driver side switches. If so, is it set to block? Also try pressing on and off a few times( maybe bad /corroded contacts inside the switch} . try the switch at each window{replace as necessary} there will be CIRCUIT BREAKERS not fuses you can check, also maybe window relays ,BURNT wiring, bad main switch,{master window} the last thing i would check is the motors themselves,doubt they would both be burned out!!! DAN F A.S.E. CERTIFIED TECH

http://www.permoveo.ltd.uk/tabid/122/OBD-Error-Code/P0578/Diagnostics/Land-Rover/Default.aspx Look at what the codes mean at this link. Note codes are P0355 + P0755. you need to change the dropdown list on the right to hyundai.

My first guess would be a sticking pump relay.

You might need to fluss the radator out with a hose pip. take the botom hose off and take th radator cap off. then crank the car up. stick the water hose in the top of the radator were the cap you took off and let the water run throu the radator for feww min.

The MAP sensor on a 2000 Hyundai Elantra will be located directly on top of the intake manifold, 3-4 inches to the left of the throttle body (facing the engine), and attached by two 10mm bolts. However, some 2000 models may not have a MAP sensor, since it was added midway through the production year to prep for the updated 2001 elantra.

Did you check for voltage at the relay ?The computer grounds the relay when engine temp reaches about 230 degrees or the ac high pressure is above 200.Can you jumper the relay contacts to make the fans run ?

if you need to remove the axle from the spindle side then you need to take the axle nut off which you have to remove the rim n tire and it will be dead center approx 1in size nut or bigger not sure exact sizesecond have to remove the nut on the lower ball joint n seperate the lower control arm and strut. will need a ball joint fork which you can get at any parts store and a pry bar to push down on control arm once ball joint is broken loose to seperate the strut. this will allow you to push the axle back troungh the spindle to remove it. last but not least where the axel goes in to the transmission you will need a small pry bar to pop it out from transmission. jus put it between axle n transmission and apply pressure till it comes out. the axel has a oring style clip which holds it in place so not able to pull it out by hand. caution when you pull the axel it will leak out some fluid so make sure you have a drain pan . to install jus follow the process backward jus make sure the axel pops back in place securely other wise when you go to drive it you risk it poping out. good luck n hope this helps you

You can look the price of the part up on the auto parts websites, and you'll need to check with a local mechanic for the labor.

Could be the second fan motor or a relay. Have the circuit tested for the second fan.

very possibleyou need to have a mechanic check the fuel pressure with a gauge

Overfull is never a good thing. Take it back to where the work was done and speak with the manager. He may have an inexpierenced tech working for him and he doesn't even know it.

Check for burnt fuses or a broken wire. If the relay is accessible check the wires at that point to see if they are carrying power. If so, and the relay is not responding, thne a new relay is in order.

check your CV boot

Steam clean the entire engine and then drive it a day or so and put it on a car lift and look for the leak, No magic bullet on oil leaks.

In most cars the brake pedal activates a solenoid to unlock the shifter.There should be a button near the shifter you can push to unlock in an emergency. It may take a screwdriver to push into a slot depending on your model.

its the cam shaft or drive shaft sensor. since your probably trying to restart it over and over again you are resetting the computer so you get no codes. have a 2000 and it did the same thing tell i gave up trying to start it and took it towed it to my house and had it tested.

check for spark check for fuel check for power to the injectors

For Automatic transmission problem,Check the list of help links below.click the link below:----Automatic transmission troubleshooting:----

http://howtobyme.blogspot.com/2011/11/automatic-transmission-will-not-go-into.html

---------Automatic transmission shift lever issues?-------

http://technoanswers.blogspot.com/2012/01/automatic-transmission-shift-lever-hard.html

-----------AUTOMATIC TRANSMISSION FLUID LEVEL? --

http://schematicsdiagram.blogspot.com/2011/07/how-to-check-automatic-transmission.html

--------------

AUTOMATIC TRANSMISSION FLUID AND FILTER?

http://schematicsdiagram.blogspot.com/2011/07/how-to-change-automatic-transmission.html

-----------Transmission fault light on car dash?

http://schematicsdiagram.blogspot.com/2011/12/transmission-fault-light-on-car-dash.html

--------Transmission shifting problem?

http://schematicsdiagram.blogspot.com/2012/01/transmission-shifting-problem-on-toyota.html

--------Transmission Slips out of 2nd gear?

http://repairhelpcenter.blogspot.in/2012/02/transmission-slips-out-of-2nd-gear.html

-----------OD light flashing and transmission fluid leaking?

http://repairhelpcenter.blogspot.in/2012/02/od-light-flashing-and-transmission.html

----------Why Transmission fluid leaks near radiator?

http://repairhelpcenter.blogspot.in/2012/02/transmission-fluid-leaks-near-radiator.html

----------transmission fluid leaking?

http://technoanswers.blogspot.in/2012/02/ford-windstar-transmission-fluid.html

-------------****** wont go in reverse?

http://technoanswers.blogspot.in/2012/02/dodge-neon-wont-go-in-reverse.html

-------------Automatic transmission will not go into reverse?

http://technoanswers.blogspot.in/2012/02/dodge-automatic-transmission-will-not.html

----------Transmission is making buzzing noise?

http://technoanswers.blogspot.in/2012/02/transmission-is-making-buzzing-noise.html

-----------

This will help.

Thanks.