20 Most Recent
1998 Jaguar XK8 - Page 7 Questions & Answers
I have a 1998 jaguar xj8 i changed the steering
Did you turn the key on at any time when the wheelspeed sensor (this is what detects the rotation of the "ABS ring") was disconnected? You may have to interrogate the ABS controller with a diagnostic computer to read the diagnostic trouble codes and then clear them. Also, you may have to drive the car 10km per hour for a few moments after the codes are cleared to get the light to go out.
I have a 1997 XK8 Coupe, the battery is dead and I
ACCESS WITH KEY TO TRUNK:
There is a trunk lock cylinder in the trunk emblem between the "X" and the "K".
JUMP BATTERY INSTRUCTIONS:
You can jump the battery lug on the fuse box under the hood. Open the hood and you will see the positive cable under a rubber boot in the front of the driver side shock tower. Install the positive cable of you jumper to that lug and the negative side to a nut on the strut tower. There may be a plastic cover over the strut nuts that will need to be pulled of. This should give you enough juice to open the trunk.
The fan does not come on at all and overheats at
hi did you check youer fuses and relays for the engine fan if all good .
check the fan and see if it is geting power.
it well have power after engine is at temp. if no power
check the engine temp sensor.
Cannot open trunk with keys or trunk butto. Valet
It means that the trunk is locked with a code( Usually entered with the radio buttons) that prevents any valet service from raiding your personals in the trunk.Check your users manual for the card that contains the code. It is like the radio code that if stolen will not work until the right code is entered. Your Jaguar dealer will be able to help you as like the radio it is tied to the vin# and I think the radio serial number on some models
Please rate my help++++Thankis for using FIXYA
Driverside inside door won,t open the dr or even
more likely the door handle mechanism is either broken or came undone, the only way to get to it and see what broken or came off is to remove the door cover panel, its not easy job and its time consuming if not mechanical incline although it something fairly simple to fix and repair. you may just have to replace inner door handle if it broken off from the linkage.
Not finding what you are looking for?