1
Begin by sliding under the front of the car and locating the radiator drain plug on the bottom of the passenger's side of the radiator. Slide the catch container under the drain plug. Use the socket set to loosen and remove the plug. Allow all the coolant to drain out of the system.
Follow the coolant line that comes out of the bottom of the radiator and enters the engine block. Where the line enters the block, there is a small oval cover. Use the socket set to remove the two screws holding this oval cover on. Below the cover, you will find the thermostat.
Pull the thermostat out and then slide in the new thermostat. Replace the cover and tighten down the mounting screws. Unscrew the radiator cap and fill the system with a 50/50 mix of water and radiator fluid. Start the car and see if it cools down like it should.
446 questions posted
Usually answered in minutes!
1,180 Questions
1,029 Questions
656 Questions
508 Questions
493 Questions