20 Most Recent 2005 Lincoln Town Car - Page 3 Questions & Answers

If it has the "locksmart" PAT(passive Anti Theft) option,there is a chip in the black plastic "head" of the key,that is mated to a reciever in the steering colum, a magnet would most likely mess the system up. It kills the fuel,hence the no start. If you have another key,try that,if not ,take the key off the ring and try it. Odd thing about the dash lights,but the key switch "talks" to the computers so maybe. My best thoughts on your problem. let me know.

take keys out of car with you and lock all doors, then unlock door with the key and retry cranking vehicle

fuel rail pressure sensor "a" circuit highpossible causes : frp signal shorted to vref or vpwr or frp signal open or damaged frp sensor

Perhaps it just needs lube?..or the elevtric switch is just done and needs to be replaced

How do I replace a keyless entry pad

Try disconnecting the battery for 5 minutes. then when you reconnect the battery lock and unlock the drivers door with the key, door closed. this will on some models deactivate the anti theft system. but it must be done with the hood closed and all the doors closed and from outside with the key. mike

To remove the struts on a Mystique, Loosen the lug nuts on both front tires. With a hydraulic jack, raise the vehicle on one side, then place a jack stand under the vehicle and adjust it to the proper height for the vehicle to rest on. Repeat this step for the opposite side.--------------------------------------------------------------------------------ECU Chip Tuning Tool

Exhaust Gas Recirculation Flow Insufficient Detected. Check to be sure egr is clean and free of carbon deposits to check function apply - vacuum with a vacuum pump and the engine should stumble if it doesn't shut off the engine and apply vacuum and hold if you Apply 51-74 kPa or. (15-22 in-Hg) It should stay at that pressure for a pre determined amount of time let's say 1 minute if it doesn't the diaphram is bad on some egr's this can be replaced separately if it does hold remove the egr clean and inspect bench test with vacuum if it doesn't work then it works after cleaning it was just dirty and can be re-installed with a new gasket if you clean it and it still doesn't move in and out replace it

The code is for a problem with the flow in the EGR valve.Could be a problem with the valve, or the line, or the sensor.

What can we do for Dawson today"Lincoln acting up.

You should be able to jump start it. Before connecting cables make sure the ignition is off on both vehicles also do not let the black and red jumper cable clamps touch . When connecting cables connect the red cable to the good batterys positive terminal first. Next connect the other end of the red cable to the positive post of the dead battery. Third connect the black cable to the good batteries negative terminal. Last connect the other end of the black cable to a good ground on the dead car, this can be a nut or bolt or part of the frame. Start the engine of the good car, rev the engine slightly then try to start the good car. Remove the cables in reverse order from installing them.