20 Most Recent
2006 Saturn Sky Questions & Answers
There is a high-pitched whine
It seems like what you've discovered is something that will produce the noise based on the amount of wind speed. I'm imagining that you should look for something loose such as a piece of weather stripping, a crack, or an adjoining section of body panels where the gapping may be larger than the other side.
2003 Saturn Vue 2.2 liter. Why is it stalling and the codes are P0340 and P1599. The car doesn't have a camshaft position sensor?
Circuit Description
This ignition system does not use a conventional camshaft position (CMP) sensor that detects valve train position. The ignition control module (ICM) detects when #1 or #3 cylinder has fired on its compression stroke using sensing circuitry integrated within each coil. The sensing circuit detects the polarity and the strength of the secondary voltage output, the higher output is always at the event cylinder. The ICM sends a CMP signal to the engine control module (ECM) based on the voltage difference between the event and waste cylinder firing energy. This system is called compression sense ignition. By monitoring the CMP and crankshaft position (CKP) signals, the ECM can accurately time the operation of the fuel injectors. If the ECM receives an intermittent CMP signal from the ICM, the CMP Resync Counter on the scan tool will increment. When the ECM cannot use the information from the CMP signal, DTC P0340 will set.
Diagnostic Aids
• The following conditions may cause this DTC to set:
- Low resistance in both the #1 and #3 secondary ignition circuits
- High resistance in both the #4 and #2 secondary ignition circuits
- An intermittent crank signal
• An Intermittent crank signal will result in an interrupted cam signal and may set this DTC.
• To locate an intermittent problem, monitor the CMP Active Counter parameter while running the engine with a scan tool. The counter should continuously count up to 255, then reset to zero. The counter will stop counting if a fault occurs in the cam signal circuit.
If this DTC is determined to be intermittent, refer to Intermittent Conditions .
2006 Saturn Ion 2.2l after driving the car, I park and turn the car off I can't get the key out why?
This could possibly be one of two things. An old, worn ignition key or a faulty shift/park solenoid.
If you are going to replace the key DON'T recut the key you are using now as you are only copying a Bad key. Get a brand new key from the Dealership. You will need the VIN number to do it.
The solenoid is located on the side of the gear shifter housing under the centre console so you will need to remove it to get access to it.
Location of MAP sensor on 2006 Saturn view 2.2 L
The Manifold Absolute Pressure (MAP) sensor on a 2006 Saturn View 2.2 L is located on top of the cylinder head, right side, about 2/3 of the way back. There is one screw holding it in. You will need to take off the plastic engine cover off to access it. The sensor in the airbox is the MAF sensor. Mass Airflow Sensor.
Not finding what you are looking for?