20 Most Recent 2001 Hyundai Santa Fe - Page 7 Questions & Answers

How is your transmission fluid level? There should be a dipstick to check it. Check with engine running and transmission in"Park".

this schematic should help, No 6 by the thermostat housing

no story, why are you asking sensor questions.? lost it. it fell off, it was in a wreck, the pack rats eat it all up. (common) context, put us on the same page, and we can answer accurately or post symptoms. or both. ill answer for rats killed my sensor. get the FSM its all there. or log into alldata.com and click wiriing. pages. , tranny easy huh.? DIY and only $15 lousy bucks too. that is what we do, for all our cars, and trucks. the FSM is at Hyundai, get one. and do all service on car. not just 2-4 wires.

probably a bunch of gravel up in there. Exhaust pipe is loose as well expect it to fail soon.

need to remove the plastic trim where belt retracts to slide up out of way and inspect seat belt retractor drum for debris jamming ratchet or against locking mechanism check belt is not twisted and last look for rust

code p0500 refers to vehicle speed sensor(VSS) --circuit malfunction====causes--wiring-- VSS --ECM The VSS is normally located in/at the rear of the gear box.

EASTYORK AUTOHAUS AND AUTOELECTRIC TORONTO ONTARIO CANADA 647-347-3622 Antony Hi it is under the car at the top of the fuel tank next to the fuel pump

CHECK PLUGS,COILS,AIR FILTER.

OVERHEAT!?

AUTOMATIC OR MANUAL XMISSION?CLUTCH IS DEFECTIVE UNDER THE DASH DRIVER'S SIDE.

Speed sensor

sensor two (downstream) is an O2 sensor that measures O2 content in the catalytic converter, it has no effect on drivability, but if the car runs well, you probably have some sort of exhaust leak before that sensor. If it runs bad, you may have a clogged cat. Also, check with a scanner that does Data reading to see if that sensor is basically giving the same readings, not varying millivolt readings from about .1 to .9 volts like the upstream sensors.

Fuse 3 10 amp fuse is blown. Go to the parts store and they will give you the proper fuse to put in. Really easy. http://ts2.mm.bing.net/th?id=HN.608008107502731413&pid=15.1&H=181&W=160