20 Most Recent
1999 Bentley Arnage - Page 2 Questions & Answers
Service light
This means the car needs a service.
Take it to your dealer and the will look after you.
Remember. You can not run a big car on a few pounds................
Shocks
Remove the rear covers from the head light unit.
Put these cover in the bin.
After 2 days the head lights will be ok?
I had this problem with my Arnage and it's never happened again.
I have had this one now 3 years
I have a 99 bentley
the latch is in front of the engine to the right side of the car right above the headlight.
Bouns with hard ride
re arnarge hard ride you willreq 2 rear suspension spheres then bleed hydrolic suspension oil for this is rh5000
99 bentley arnage suspension light
Unfortunately they make this propriatary information and require their own computer to do so. I wish that I had better news. You can call Alber's Rolls Royce in Zionville @ (317)873-2360 and the service dept. there may be able to assist another professional (you) in getting the secretive codes. They have always been good to me.
Rear suspension feels very soft, auto ride light
U need to have ur shock absorbers checked, they might be worn and need replacement. Also the coil springs may need re-tension. U should watch ur car's normal gvm, becoz if exceed, it has damaging effects on the suspension.
How to Test the O2 Sensor of Bentley Arnage car?
O2 sensor needs to be replaced when you get low gas mileage in car.
So before replacing the sensor it needs to be tested.
The procedure to test O2 sensor is as follows: ---
1) First drive the vehicle for 15 minutes in normal temperature.
2) Then Stop the vehicle in park mode and turn the engine off.
3) You will see primary O2 sensor on the exhaust manifold, the manifold will be very hot to touch so take care.
4) The function of O2 sensor in the car is to measure the amount of oxygen in car and then send that information to engine to adjust fuel pressure.
5) Now to measure the O2 sensor reading. Carefully disconnect the wire at the O2 connector, and hook the positive lead of volt meter to the O2 sensor side of the connector and connect the positive lead of volt meter to harness side of the connector.
6) In the O2 sensor you will notice two black wires that are not used for testing.
7) Now before beginning the important part of the testing procedure, check out properly that wires of O2 sensor and wires of volt meter are not getting touch to any other metal part or the manifold.
8) After checked and confirmed. Now start the car and see the voltage in engine idle position.
9) The reading will go high or go low but the average reading that it should show is 500 mV.
10) Now let the engine run and with engine running disconnect the fuel pressure regulator vacuum hose, and plug the hose with your finger.
11) The 500 mV reading will go to 700-800 mV.now remove the finger the reading will fall low to 300 mV.
12) But if these readings are not showing properly that indicates the fault in the sensor.
13) The secondary O2 sensor is located after the catalytic converter. The procedure to measure secondary O2 sensor is exactly the same like how you measured the primary O2 sensor.
14) The secondary oxygen sensor is located under the car.
15) Put the car on jack stands on the rack, this will give you proper sensor location in the car.
16) You can test secondary O2 sensor to conform the fault before replacing the O2 sensor.
17) The cost of replacing the O2 sensor is near to $100.This cost is for if you do it yourself.
This will help. Thanks.
Radio for 2002 Bentley Arnage T
Be sure to check fuses. You may have a blown fuse. If have the owner's manual, check for fuse block diagram and check for one listed as radio. If fuse is at fault, may have loose wire that caused it to blow.
Not finding what you are looking for?