20 Most Recent 2002 Suzuki Vitara Questions & Answers


have the charging system checked by an accredited auto specialist shop
include a load test on the battery and drive belt tension and condition
indicates problem wiring or voltage regulator

2002 Suzuki... | Answered on Jan 31, 2018


Check /replace thermostat

2002 Suzuki... | Answered on Jan 29, 2018


That's the symptom of a leaking head gasket. Is your coolant level low?

2002 Suzuki... | Answered on Jul 19, 2017


It is time for a transmission rebuild.

2002 Suzuki... | Answered on Jun 08, 2017


Check the actuator motor on the inside of the car on the heater. It shifts the doors of the unit to let the heat and ac shift.

2002 Suzuki... | Answered on May 03, 2017


no country stated?
gas. ok,...
now engine stated.? G16, or j20? radially different they are.

i cant see which CMP you have
the huge puck type,
or the same with extractable small CMP sensor
the latter is easy swap
the former must be timed using the timing freeze jumper clip.

no story here, the full story
one day, it stalled.
then i scanned it and 340 popped
or got 340s after the new sensors.????????

no matter check for spark.
if got spark x4
check timing,? yes, timing light work on dead engines. sure do.
if timed wrong, then you did that.
if G16 engine the cam belt slipped,
j20 is chain drive cam.
j20 has CMP sensor on the left rear DOHC cam.

if sparks ok, test fuel now works, sprayed.

e90b02ff-5a58-43b9-bec8-a0255e3a5254.jpg

2002 Suzuki... | Answered on Mar 07, 2017


IGNITION KNOCK (DETONATION) SENSOR the knock sensor Is on the back of engine (driver side on LHD vehicles) under the cam position sensor. it is a giant PITA to change. i had to cut a wrench in half (7/8 i think??) and use a pry bar to break loose the sensor..
((found this info from a Suzuki forum.))

So how bout that knock sensor Suzuki Forums Suzuki Forum Site

Ignition Knock Detonation Sensor fits 1999 2009 Suzuki Vitara XL 7 Aerio

http://www.autopartswarehouse.com/shop_parts/knock_sensor/suzuki/vitara.html

P0325 Knock Sensor Diagnosis EricTheCarGuy

2002 Suzuki... | Answered on Feb 04, 2016


Check fuses.

2002 Suzuki... | Answered on May 14, 2015


If the system is empty, it can take as much as 32 ounces of refrigerant (R134). If the system has been allowed to become empty, make sure you use the correct PAG OIL with the refrigerant, and use a proper refrigerant gauge when recharging to avoid overcharging the system.

2002 Suzuki... | Answered on May 14, 2015


it the H25 engine, for sure.
hood off.
hoist i place.
and then 30 more steps, im not typing them.
i have the fsm s and same cara.
alldata.com, log in and read. please.

https://www.scantool.net/software/alldata-diy-1-month-subscription.html


it comes out like all RWD cars, watch you tube yet? hundreds of examples are there.

2002 Suzuki... | Answered on Apr 18, 2015


I would suggest a compression test as an engine with those miles on it will be close to being badly worn
If thee is a chain problem it will not be running

2002 Suzuki... | Answered on Mar 18, 2015


yes, the J20 engine, or H25 H27?
each has different tension-er methods.

the car is metric, there are no SAE parts on car. (no 1/2" parts)
why post engine questions, with out stating the engine.??
so ill guess J20?
how to adjust part 10? (twin cam 2.0L) I4
page 18: seen here.
http://www.fixkick.com/engine/20Liter/html/image_18.html
this is a spring type tensioner, #10 ID
seen here, clearly (has 2 mount points (fixed)
so is preset tension, ending all speculation on this. see last photo below.
-------------------------< v6>------------------------------------------------------
or the V6 ,
so happens I own one too,
and guess what, there is No tensioner like poster stated. above.
NADA..
I have the FSM for car, Page 1F-15, see that photo in the FSM
the Alternator telt adjust the tension. same as the G16 engines

if you need the real FSM page., ask for it,
or read it here.
costs only $4 bucks to read it, and down load it you can

https://suzukipitstopplus.com/Products/1194-2002-vitara-grand-vitara-service-manual.aspx

next time you have a question, you can look first.
then ask.
tension spec, is 10mm deflection at 22lbs force to belt. mid span.
7-11mm is range.


all answer USA cars, on this USA forum.

the 2.5L has 2 belts.
one has and idler. the other is alt tensioned.
the fsm cover belt 1, in cooling (alternator telt)
the FSM cover belt 2 under, P/S steering pump
and is not a spring loaded tensioner as poster guess.
its manual idler pulley with 2 slot base and 2 bolts
and needs a 12mm box end or socket to set.
and is set to same spec (tension) as the other belt, (22lbs)
if you need FSM pages, or real photos off my car, I have it
not bs.


Below is 2.0L fan belt side tension device
if you look close, see that spring there> at 7pm?


25484956-4psbqasysljj1mct2g5ek24h-1-0.jpg

2002 Suzuki... | Answered on Feb 27, 2015


the oil level should be between the two holes in the dip stick.

2002 Suzuki... | Answered on Jan 23, 2015


hello anon.
2wd or 4wd car?, this Counts big time? i toss coin; land 4wd.
The USA car can be Vitara or Grand Vitara. and cut in dates vary for that too.
the 2002 has no end locking hubs.
so you must mean front wheel bearing hubs.
ok its easy with tools.

GOT TOOLS?
http://www.fixkick.com/hubs/FW_BEARINGS.html#newer

to be accurate i need full spec on car
country
engine sizes. and if 2wd or 4wd.

my guess is your car has the unified hubs. (bearings can not be removed)
you unbolt it.
you put the new hub on
you torque it to 123-180 Ft/lbs, this is the running torque not a preload)
if not, it will fail fast.

that page even has the FSM chapter page there. to see.
from a real Suzuki, 2004.
can be seen tool, at alldata.com
or at suzuki pit stop , dot com (google it) its there.

2002 Suzuki... | Answered on Sep 28, 2014


Not really possible. True vapor lock only happens on vehicles with carburetors. The gasoline would vaporize from excessive heat before reaching the carb.
What are your symptoms ?

2002 Suzuki... | Answered on Aug 04, 2014


no engine, stated. no joy.
sorry.
some have 3 engines that year.
the 2.0 and 2.5L are all HLAs and there is no lash
but you said, valves, adjust what> do say what.
time the cam.? we cant guess what you are doing
why not just flat say so.????
eg.my valve covers are ticking ? or the cam cover, or what.
use a $5 stethoscope and listen and no more guessing where.

2002 Suzuki... | Answered on Jul 23, 2014


this is in the operators guide. lost that?
https://suzukipitstopplus.com/Products/1040-2002-vitaragrand-vitara-owners-manual.aspx

my car has no side lamps per ce'
it has bumper side lights. is that it?
try to be exact in statements. of location.
in this case front left, bumper side light , helps the helper best.
and now the answe,r off the lost book.
i open my opr, guide to page 5-53 it says
remove the 2 screws on the lens, take off lens, behold
a lamp to change,
it's done with the assembly out from rear, twist lock turned from rear
the pull it and then take out the lamp. form said socket. (pulled)
down load the lost manual and keep it on a memory stick

ive posted this 2 times here.

2002 Suzuki... | Answered on Apr 21, 2014

Not finding what you are looking for?
2002 Suzuki Vitara Logo

135 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Suzuki Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Vitara Suzuki

  • Vitara Suzuki

Most Popular Question

2001 suzuki vitara will run about twenty

  • Cars & Trucks
Loading...