20 Most Recent 2005 Chrysler Pacifica - Page 2 Questions & Answers

This is not going to be a DIY fix. Get it to a transmission shop.

2005 Chrysler... | Answered on Jan 28, 2018

Check the dome light, there is supposed to be a three-position switch; off, on constant and on when door opens...try that switch and see if the lights come on...if that doesn't work, check the bulb to see if it is burned out and if that doesn't work, check the fuse panel for a blown fuse...

2005 Chrysler... | Answered on Jan 10, 2018

hi there.
A car that jerks when starting it, when accelerating or whilst you're driving is showing symptoms that something is wrong, though there can be many causes: it can be problems in the starting system, fuel, engine or the exhaust pipe. You may even notice that your car engine light has come on to warn you of a problem. Getting to the problem at the first symptoms can avoid more serious break-downs. In one HOWTO we'd like to give you some advice so you know all the possible reasons and answer your question: why is my car jerking?
  1. Car jerking caused by a blocked catalyst
  2. Jerking caused by a fault in the spark plug
  3. Car jerking because of a drained acceleration cable
  4. Car jerking because of dirty injectors
  5. Car jerking because of the motor winding
  6. Accumulated waste can cause the car to jerk
  7. Car pulling.
  8. Car jerking caused by a blocked catalyst Car jerking can be caused by a blocked catalyst, which leads to gases not being ejected as they should be. The result is that, until the car doesn't rev, the car jerks. If your car has a blocked catalyst you will also notice the following symptoms apart from the jerking.


    • The 'Check engine' light will turn on
    • Your car jerks when accelerating
    • The car's fuel efficiency will have dropped
    For more extended information, take a look at our article on the symptoms of a blocked catalyst. The best you can do if your car is jerking due to a blocked catalyst is to visit a trusted mechanic to fix it.
    Jerking caused by a fault in the spark plug Another cause for jerking can also be a fault in the spark plug or one of its cables. You will know this is the case if your car jerks when you start it in the morning. The symptoms are very similar to a blocked catalyst, but if it's a problem with a spark plug, you'll notice the following too:


    • The engine will make even more noise than it usually does, like that of an airplane.
    • It jerks when accelerating but also when you start the car
    In this case, you can solve the problem yourself by changing the spark plug. If you don't have the skills to change the spark plug yourself make sure a professional solves this problem.
    It is very important to keep the spark plug clean, so you can avoid car jerking and other more problems.
    Car jerking because of a drained acceleration cable A car jerking can also be a result of the acceleration cable being very worn out. You will notice because of the following symptoms apart from the jerking:


    • Your car takes extra time to respond when you press the accelerator and starts jerking.
    • If you take a look inside, you will also notice that the outer covering of the acceleration cable will be damaged.
    The best you can do is change it as soon as possible, as the car will stop at any moment if you leave it to break. Take the vehicle to a mechanic to solve the problem. If your car has this problem, take a look at our article to know all the reasons why your car jerks when accelerating to find out what it may be or try adjusting the acceleration cable if you are handy with cars.
  9. Car jerking because of dirty injectors Another cause for car jerks are dirty injectors. This is not such a serious problem but should know it needs solving too. You will notice your car is jerking for this reason if:


    • Your car also loses power
    • Your engine misfires frequently and jerks and stutters frequently and/or continuously while driving normally.
    It's best to clean them regularly to avoid costly reparations. You can do this yourself using a specific cleaning kit, which are quite cheap and can be found almost everywhere.
    Car jerking because of the motor winding The car's engine/motor winding can be another reason for car jerking. Wear of the engine's winding is most likely caused by the engine being put under stress - i.e. through hard acceleration.


    • If your car has more than one winding and one of them is broken, the car will jerk.
    • In the case there's only one winding, the car will not start.
    The only way of knowing if this is the case is through the use of an Ohm meter, so if you don't own one it's best you check with a mechanic to know if this is the reason your car is jerking.
  10. Accumulated waste can cause the car to jerk Jerking can also mean the fuel filter is blocked because too much waste has accumulated. To make sure this is the case you can learn how to tell if your fuel filter is bad. If this is your case,go to your mechanics to solve the problem or you can also try to clean your fuel filter at home.
    These are the most common causes of a car jerking, however, your car could have another problem that needs the help of a specialist. If you're not sure of what is happening to your car it's better to bring it to a mechanic. The specialist will find the root of the problem.
  11. If you'd like to read similar articles to Why is my Car Jerking - All Possible Reasons, we recommend you browse around our Car Maintenance and Repair category.

2005 Chrysler... | Answered on Dec 14, 2017

I think you should buy repair manual first for your vehicle after that it will be easy for you to solve the problem. Check the link may be you will find something useful here
Best Manuals

2005 Chrysler... | Answered on Dec 07, 2017

Para abrir la puerta trasera el?ctrica, presione y suelte el bot?n "Levantar puerta trasera" en el control remoto de entrada sin llave dos veces en cinco segundos. Alternativamente, puede presionar y soltar el bot?n "Levantar puerta trasera" - el bot?n derecho, atr?s - en la consola superior para abrir la puerta trasera el?ctrica.

2005 Chrysler... | Answered on Dec 04, 2017

If you don't have a shrader valve, you have to put a "T" pipe on the connection to the rail. If you want to just check the pump, you can remove the regulator and adapt to the regulator port on the rail. Most gauge sets include this kind of hardware, or else you can find one at your local parts store.

2005 Chrysler... | Answered on Nov 09, 2017

There is a relay located in the under hood fuse box , front blower motor relay .Plus a fuse ,fuse #42 40 amp. The relay is controlled by the integrated power module . There are two type systems ,one has a resistor block an the other uses front blower power module . (computer) Check out the wiring diagram here http://www.bbbind.com/free_tsb.html Enter vehicle info. year , make , model and engine size. Under system click on HVAC ,then under subsystem click on HVAC controls . Click the search button then the blue links. I think the difference is a manual or automatic system . Which does your's have ?
Blower Motor Runs all the Time

2005 Chrysler... | Answered on Oct 24, 2017

Close to the fan motor there is a multiple resistor that feeds the fan motor. Check that.

2005 Chrysler... | Answered on Oct 10, 2017

It sounds to me that your problem is above the headliner. There are drain tubes at each corner of the sunroof pan that allow water to drain under an outside of the vehicle. It sounds like one of the front tubes has either cracked, come off, or are just plugged up and allowing the water to overflow the pan.

2005 Chrysler... | Answered on Oct 04, 2017

You can try unhooking the battery for a few minutes, both terminals, and then touch the two together before hooking them back up. If this doesn't work then you will need to see someone with a code reader capable of resetting it.

2005 Chrysler... | Answered on Sep 15, 2017

Typcially, is these mini-vans it is on the rightside (interior) wing panel, the ECU is on the leftside wing panel. If you start at the torque converter solenoid and trace the wiring loom it leads straight to the TCM.

2005 Chrysler... | Answered on Aug 19, 2017

The car does have a maf, but it is rarely the cause of rough idle. Rough idle is usually caused by vacuum leak, pvc issues, or idle air control valve. What does it do, specifically, and is the engine light on?

2005 Chrysler... | Answered on Jul 23, 2017

You need to get your codes read by somebody that know their posterior from six bits...

Sounds like your EXHAUST SYSTEM to me...

Check out your parts & prices before going in.. RockAuto Parts Catalog

2005 Chrysler... | Answered on Jul 22, 2017

One doesn't. There's no way to bypass it

2005 Chrysler... | Answered on Jul 06, 2017

Not finding what you are looking for?
2005 Chrysler Pacifica Logo

1,647 questions posted

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

85160 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Pacifica Chrysler

  • Pacifica Chrysler

Most Popular Question

2005 chrysler pacifica license plate

  • Cars & Trucks