2005 Cadillac Escalade - Answered Questions & Fixed issues

PARK IS DEAD,BUT LEVER SHOWS PARK BAD SHIFTER OR BAD LINKAGE TO IT. BAD CABLES. THIS IS PURE PHYSICAL MECH. FAILURE NO MAGIC COMPUTERS, L

see a local tire dealer . the sensors do go bad

I need to know what the box is called under the truck that the brake lines go into for a 2005 Cadillac EVs

The valve is located under the rear of the car, passenger side, above the rear axle.

Remove the arm rest door to the center console (Philips screws in the hinge first, pull the bezel around the CD and Heat control, then take out the rubber from the cup holders and remove the screws, also remove the screws inside the center storage compartment. You should be able to remove the center storage compartment and gain access to the area underneath.

hello u will find a lot of wiring diagrams and circuit diagrams help books and stuff like this at reliable-store the girl in the chat box can help u instantly... im a frequent buyer there since Im a mechanic so take help from there

Best bet for a wiring and parts location diagram is alldatadiy.com. There is a switch attached to the chassis (with a rod connecting it to a rear control arm), on or near the air pump at the rear of the truck.The switch could be faulty, or the rod may be disengaged or damaged. The pump is rather expensive - I would remove it for cleaning (in particular the air filter) and testing first.

Visit the on-line store, know as reliable-store, they have the repair manuals. I'm sure you will get the solution of your problem. Best Manuals

to big an area to guess run the fault codes to narrow down the problem area and fix what shows up

Get your ac recharged. Can go to part store and get get a can of freeon and do it yourself.

Passenger side under the dash behind the glove compartment

Not fused

could be blown fuse loose wire or blower is burnt out

theres no reset button you need to get code checked and fix problem

Most often either a fuse blown, or misadjusted brake pedal switch ( the one that kicks it out of lockup when you touch the brakes)

Remove radio ,take off cover ,and replace bulbs. Use clean cloth when installing bulbs, skin oil kills bulbs. GOOD LUCK FRIEND.

The bulbs are probably burnt out. You will need to replace. Put key into on position, lower steering wheel, front cover over instrument panel should pop off start at top and work around, Remove instrument cluster (4-6 bolts) pull cluster toward yourself. Bulb holders are on back. Unscrew left or right ,bulbs are in holders, get the bulbs you need and reinstall. Use a cloth to replace bulbs, skin oil makes for short life of bulbs. When done go in reverse. GOOD LUCK FRIEND.

This sounds like a encoder, you need to pull the error code for this. Not all readers will give you the ABS codes. You can try at the local auto parts store, most of them will pull the codes for you.

Check the switched to see if there is dirt in or around them. Sometime, through use, you can get a buildup of dirt and the switch stays activated. I sometimes use a 90% isopropyl alcohol to clean, but be careful, some plastics can be affected.

look up at the starter area