1990 Honda CRX - Answered Questions & Fixed issues
Put a brand new battery
Found this wiring diagram for your generator. I didn't see fusible link? The bat terminal at your generator, should be hot all the time, even with key off. It's a straight shot to positive side of battery. In the diagram, it goes through the 60 amp fuse. If that is the problem, you could leave a pig-tail at the generator and battery, run a new wire, proper size with an inline fuse, bypass the fuse box. As long as that is a dedicated fuse, I don't see why it wouldn't work? Of course, I can't see anything from here. Just my opinion.
3/11/2018 6:45:06 PM •
1990 Honda CRX
•
Answered
on Mar 11, 2018
•
53 views
Engine cuts off while drving. May be related, the
Check the coolant level in the radiator at the cap as it may be the low coolant warning system that is activated as the water runs away from it as you change direction. If it is serious enough the engine light will come on and the CPU will send the engine into limp home mode.
10/27/2013 12:52:00 AM •
1990 Honda CRX
•
Answered
on Oct 27, 2013
•
101 views
Honda A1 and S1 transmission same
its different model cars it came off. same tranny. and yes you are wrong im currently using an a1 tranny and if its automatic im doin it wrong :)
3/24/2013 5:14:49 AM •
1990 Honda CRX
•
Answered
on Mar 24, 2013
•
484 views
Engine problem
You might want to check for any possible vacuum leaks from the back of the intake manifold. A severe enough vacuum leak will cause the engine to spit and sputter. You may also want to check the egr valve stuck in the open position as well. Also caused by possible vacuum issues. Vacuum within the intake will increase with accelaration and if you have a cracked line it could cause the symptoms you are describing.
Good Luck
11/28/2012 9:31:01 AM •
1990 Honda CRX
•
Answered
on Nov 28, 2012
•
350 views
Steps to replace right hand side door internal window seal
I believe your car has a full frame windows? If that is correct then are you talking about the rubber the window glass slides up and down in? If so, then you have to remove the inner door panel and might be helpful if you have power windows remove the power window switch from the inner panel and reconnect to wiring harness. Using this technique, there are 2 10mm bolts holding the window glass to the regulator. Position the glass with the 10mm bolts through a couple sight holes, remove the 10mm bolts but hold on to the glass so it doesn't fall in the door and break. install the rubber window channel and reverse procedure.
1/1/2012 2:25:16 AM •
1990 Honda CRX
•
Answered
on Jan 01, 2012
•
248 views
I just bough a 1990
take it to local honda dealer ship and they will tell you for next to nothing
9/16/2011 3:15:56 AM •
1990 Honda CRX
•
Answered
on Sep 16, 2011
•
115 views
I HAVE A 1991 CRX
Yes the starter from the SOHC motor will work on the DOHC. I have done it many times myself when I had my CRX back in the day. I also had the same question when I first changed mine.
5/21/2011 8:12:48 PM •
1990 Honda CRX
•
Answered
on May 21, 2011
•
53 views
I dont know the
Firing order is 1-3-4-2...... The no 1 cylinder is located next to timing belt going to the left 1-2-3-4 the fourth cylinder is next to the distributor
4/22/2011 3:42:16 AM •
1990 Honda CRX
•
Answered
on Apr 22, 2011
•
149 views
I have a 90 crx si with a b16a vetec engine in it.
A B16A with no number fallowing it is a JDM engine. If it was a B16A1 for example it is a USDM engine. As for the idle problem its probably a tps sensor and if it idles really low rpms you should up the idle at the trottle body to idle at 800 rpms to be safe, To low of a idle will cause bearings to go out and throw a rod.
Lookj at the valve cover if it is a jdm you will know if it is a SIR or a SIR2, SIR has larger font for the DOHC and smaller font for the VTech The sir2 has larger font Vtech and smaller font DOHC. The SIR2 also has oil jets underside of pistons and rods to help lubricate piston rod conections.
10/12/2010 10:31:49 PM •
1990 Honda CRX
•
Answered
on Oct 12, 2010
•
240 views
I have an A1 transmission in my car ...the clutch
212 spine. It depends there are three different types. You need to pull it out and check to order a new one. eBay has loads once you know whch one it is either 19,20 or 21mm.
Vote for me :)
6/24/2010 4:23:56 PM •
1990 Honda CRX
•
Answered
on Jun 24, 2010
•
227 views
Not finding what you are looking for?