20 Most Recent 2002 Lexus ES 300 - Page 4 Questions & Answers

I just changed the cabin filter of my ES300. I found the instructions on the manual, under airconditioning and audio. It's pretty easy to do. I bought the filter from Kragen's for $21.95.

All of these codes are misfire codes.clicking sound is most likely spark jump from plug wires to metal(head,block,valve cover etc.)

check the alternator output

I suggest check vacuum leaks, air intake and fuel pressure.

HelloThe engine and automatic transmission in this vehicles drive train are fully electronically controlled by a computer called the PCM (Power Train Control Module). Whenever a problem like this occurs the computer stores a record of the problem (there are of course some exceptions to this, like the fuel pump, engine coolant temperature sensor and MAF sensor for instance) in the form of a fault code in its memory, to read these fault codes you must have the systems memory scanned with a special tool. Once the fault code(s) are read you then must perform the appropriate diagnostic testing to find and resolve the problem(s) DO NOT REPLACE ANY PARTS UNTIL A TRAINED TECHNICAIN HAS DIAGNOSED THE PROBLEM TO AVOID SPENDING YOUR HARD EARNED MONEY ON PARTS THAT MAY NOT CORRECT THE PROBLEM

There are two ports on the a/c lines or compressor. One is larger than the other to help prevent you from connecting to the wrong side of the system. The ports are covered by plastic caps.

you can check it with obd2 code scanner, and find where is the problem and fix it.

H20 OR 02 SENSOR ARE BAD.
THEY SHOULD HAVE 4 OF THEM UNDER THE CAR.
PRICES OR 69.99 - 149.99 DOLLARS

ok it could be alot of different things idle air is dirty or the throtle body needs cleaned. Is the gas pedal cable driving or electric (but i don't thing it is the pedal)

dear,
I have different experiance with the C.Dplayer ( error 3 ) , there is no need to remove it nor send it to the dealer ,all you have to do when you have `` Error 3 `` is to reset the C.D player , by recycling the power supply ,this can be done by disconnecting the main car battery power supply , you must also keep the battery disconnected for at least one hour . then connect the cables to the batteries ,when you start the C.D player you will hear some clicking sound ,and watch the numbers of the C.D`s in the display you will find all what is inside has been detected by the display .
and your C.D player is back to normal..

i discovered ths by chance , when I had this error in the past ,coincidently I had to replace the battery and after installing the new batteries ,i was suprised to see the player back to normal condition by its self.