20 Most Recent 1994 Honda Passport Questions & Answers

go see a dealer fuses do not click relays might

You have wires or a relay shorted together or bad grounds. You need a shop that is good with electrical to check this.

IT IS JUST LIKE BLEEDING A BRAKE SYSTEM HAVE A HELPER GET IN AND PUMP THE CLUTCH PEDAL AND THEN HOLD IT DOWN AND OPEN THE BLEEDER ON THE SLAVE CYLINDER KEEP DOING THIS 4-5 TIMES AND YOU SHOULD HAVE A PEDAL IF NOT THERE IS ANOTHER PROBLEM MAKE SURE TO KEEP THE CLUTCH MASTER FULL

Not familar with your exact transmission, but most have more than one shift solenoid. These are usually easy to access once trans bottom pan is removed.

There's a website that has all this information about all this and manuals everything totally free there are many actually but I personally like few like reliable-store .. let me know if u need help thanks

Is the transmission getting very hot ? it sounds like there is a serious problem inside the transmission, I would not drive it until you have a technician have a look into it.

Make sure your battery cables and posts are both clean and snug. Sometimes the lights will work, although weakly, even if they are loose. I had this happen on a '93 Subaru my son was driving. When I saw the mounds of residue on both cable/posts and literally was able to lift one cable right off the post with almost no effort, I knew what was wrong and cleaned the cable ends and posts. Problem solved. Hope that's what your problem is.

https://www.automd.com/repaircost/estimate/

Normal as it is the same as pulling the choke on once the ecm has run all the checks and the sensors have registered correctly then the ecm brings the rpm,s back to normal. If it lasts for a longer period then run the fault codes but 30 seconds is about average

hello there:
to replace the window regulator you will need too look for screws around the sides and bottom of the door panel then you will need to remove the door handle backing plate and the door handle where you grab too close it you see no screws there will be a round cap you will need to take out to see the screw head remove the screws and lightly pull the door panel out there will be body clips that will come out of the door then slide door panel up and pull off this will give you access to the regulator remove the bolts on the regulator and remove install in reverse hope this help you out please leave a review thanks sincerely D.Jones

The clicking sound indicates that the battery is too low to start the vehicle. Accessories such as dash lights draw very little current, so they will work even when the battery is nearly depleted. Try removing the battery cables (negative first) and cleaning the cable ends and battery posts with a wire brush or sandpaper. Then check the water levels if yours is a serviceable battery, add distilled water if needed, replace and tighten the cables, then try to jump start from another vehicle. If it starts, let it run for a while and see if it will start again by itself. If so, that may be all you need. If it continues to lose its charge, you will need a new battery. If the vehicle will not start even with the jump, you may need a new starter.

Bill B

Hey dean how's it going ? here is video on how to do it ! It's not the same vehicle but should be close ! How To Install Replace Headlight Turn Signal Switch Honda Accord Prelude...

somethins gettn hot in the electrical-components are old an worn makin resistenc--take off distributer cap and inspect for corrosion inside-clean or replace--plug wires cud be old tho they look gud outside--coil shud be tested and ignition module--may also be wiring issue in harness--or a fuel problem

Usually with the fuse panel

there could be a number of reasons for the a/c failure. do this first start the vehicle and turn the a/c on full blast look to see if the a/c clutch on the compressor is spinning. it is the center part and not just the pully. keep me posted of the result