Top 10 1995 Subaru Legacy Questions & Answers

I have a 95 Legacy Wagon and by the shop manual the therostat sets on the bottom of the water pump. It is accessed from the bottom of engine by 2 bolts that hold the lower hose on.

i had this problem with mine if your cable spins wen the car is moving its not the gear box end or the cable its the speed sensor in the speedo its self its very easy to fix you have to strip the speedo out of the case the sensor is only small and on the under side of the speedo the sensor is about 50 mm long and 10 mm wide change that and it should be ok
oh remember to reset your ecu

You can start by checking the fuel pump and testing it for current but it may also be in the starting system so check to see if the starting solenoid is working properly.

The Dipstick is on the driver side right next to the starter and yes you also put the fluid in there.

Oil is 10-30 and the type of oil filter is up to you, you can go cheap or you can go expensive it is all up to you what you want to run in your car.

Dear weelizw, Sat 02-21-2009 8:17pm EST (USA)

RE: 1995 Subura Legacy "Picture Diagram of Engine"

Try this site by clicking on the following link @ http://www.haynes.com/video.downloads

Get back if you need more help!
jack
Please Rate This by not closing but clicking you back arrow (button)!
Thank You!

According to Subaru, below 40c (104 F) SAE 5W-30 preferred
Above -20C(-4 F) SAE 10W-30,10W-40Stick with a quality oil such as CASTROL.GTX.

Hope this helps, from autozone site. Curt
Application:
Cylinder head bolt torque sequence

Note :
Torque sequence:
---------
front | 3 1 6 |
of | |
vehicle | 5 2 4 |
---------
Step 1: Lightly oil cylinder bolt threads & washers
Step 2: Torque to 22 Ft/Lbs
Step 3: Torque to 51 Ft/Lbs
Step 4: Loosen all bolts 180 degrees
Step 5: Loosen all bolts 180 degrees
Step 6: Torque bolts 1 & 2 to 25 Ft/Lbs
Step 7: Torque bolts 3, 4, 5, 6 to 11 Ft/Lbs
Step 8: Turn all bolts an additional 80 to 90 degrees
Step 9: Turn all bolts an additional 80 to 90 degrees
*** CAUTION ***
engine uses Torque To Yield head bolts (TTY) that
permanently stretch during the initial installation.
New head bolts must be used when cylinder head is
replaced or re-installed to obtain proper Torque.

If you're fuel gauge stopped working, this would not affect the fuel pump or pump relay. More then likely, the sending unit is at fault. You may check fuses to see if this vehicle has a fuse for the gauge. some do. The fuel pump has a relay under hood and also a 30 amp fuse.Has separate circuits for gauges.I would be looking at the sending unit.
Good Luck, Sinserely, shastalaker7

I have the same problem few days ago and found my solution on Fixya Expert Sources website. Here you will get all the top sources of your problem. All the sources of this site provided by top Fixya Gurus.

• tinyurl.com/fixyacarsource