20 Most Recent 1990 Subaru Legacy - Page 2 Questions & Answers

0helpful
1answer

Muffler and exhaust system

does the car run hot or the exhaust system? if the exhaust system is getting hotter than usual than it sounds like a clogged catalytic converter
8/13/2014 7:25:29 PM • 1990 Subaru... • Answered on Aug 13, 2014
0helpful
1answer

When my 1990 subaru legacy is cold it runs good then after 10 miles it starts skipping engine light comes on and a strong ordor of gas can be smelled. it does not run hot but when it starts to cut bac

Could be a faulty O2 sensor. The sensor would not take action until the engine warmed up. Have you checked for trouble codes in the engine computer ?
7/28/2014 8:16:05 PM • 1990 Subaru... • Answered on Jul 28, 2014
0answers
0helpful
1answer

Location of thermostat of nissan queast v6

Start at the radiator and follow the top hose towards the engine. Its usually where the top hose ends.
5/1/2014 12:12:47 AM • 1990 Subaru... • Answered on May 01, 2014
0helpful
1answer

Abnormal voltage codes 1990 subaru legacy

The bat/alternator could be bad. Have both tested and replace as neccessary.
2/9/2014 8:59:08 PM • 1990 Subaru... • Answered on Feb 09, 2014
0helpful
1answer

Won't turn over. Possibly a key ignition relay problem. Not sure.

Have your alternator checked. It didn't charge your battery enough. Also look at the battery. It may be sulphated and won't charge
1/28/2014 7:05:03 PM • 1990 Subaru... • Answered on Jan 28, 2014
0helpful
1answer

Ecu located

90-91, its under the dash, on the left side of the steering wheel. The ECU is the one farther towards the door. Just a side note if you need it, abs controller is under the passenger seat.
12/6/2013 8:47:42 PM • 1990 Subaru... • Answered on Dec 06, 2013
0helpful
1answer

Problems heater

Are you saying the blower motor is not blowing any air? Check for power right at the blower motor first.
11/4/2013 4:18:36 AM • 1990 Subaru... • Answered on Nov 04, 2013
0helpful
2answers

1990 Subaru Legacy C.V.

Apply parking brake place vehicle in park Jack vehicle up support with jack stands remove wheel then axle bolt bolt is a size 32mm socket then remove the two bolts connecting the shock tower to the hub and pull the hub down and slide the axle spline out of the hub then using a pry bar or large flat head screwdrivers pry the axle out of the transmission install new axle installation is the reverse of removal
10/30/2013 5:45:47 AM • 1990 Subaru... • Answered on Oct 30, 2013
0helpful
1answer

Engine turns but sounds like there is no power

Sounds like your engine has jumped time or the the timing belt or chain has broke.
10/27/2013 4:21:30 AM • 1990 Subaru... • Answered on Oct 27, 2013
0helpful
1answer

There's a rapid clicking noise when I try to start

It could be your battery , sometimes if your battery is not fully charged then it wont send enough current to the starter.To test this either use a battery charger or jumper cables coming from another vehicle and see if it starts.Otherwise it is your starter.Tap on the starter sometimes this will dislodge the problem with the windings in it. If that still doesn't work then you will have to replace your starter.
10/12/2013 7:39:36 PM • 1990 Subaru... • Answered on Oct 12, 2013
0helpful
1answer

Fuel pump located

On most cars there is a small panel hidden underneath the back seats usually a round disk with three screws ! Normally on the same side as the filler cap ! Hope this helps ;)
10/3/2013 10:06:52 PM • 1990 Subaru... • Answered on Oct 03, 2013
0helpful
2answers

Ran lw on gas now it shakes and runs rough and

Sounds very much like it has blocked the fuel filter ! Easy and cheep fix ! On older cars I try never to run fuel to low as there can be a lot of crap in the bottom of the tank !! Hope this is a help ;)
10/3/2013 9:59:15 PM • 1990 Subaru... • Answered on Oct 03, 2013
0helpful
1answer

I have "arrow" marks on the cam pulleys, what does

the marks on the crank should be a line in crank pulley.
9/11/2013 3:54:04 AM • 1990 Subaru... • Answered on Sep 11, 2013
0helpful
2answers

Need help timing 1990 subaru legacy

all the indicators should be at the twelve oclock position, the left and right notches are on the rim of the cam pulleys, the crank in the middle has an arrow on it, this is NOT the alignment mark it is on the small teeth at the back of the unit. goodluck
9/11/2013 3:00:12 AM • 1990 Subaru... • Answered on Sep 11, 2013
0helpful
1answer

Need to replace radiator

Here's a link Albert on replacing your radiator.* Extended life antifreeze is highly recommended with this vehicle cause it has a aluminum water pump.
8/17/2013 4:23:29 PM • 1990 Subaru... • Answered on Aug 17, 2013
manual
0helpful
1answer

Overheating and stalling

not good did u check trans fluid level it could cause all these symtoms after severe fluid shortages
6/24/2013 3:39:01 AM • 1990 Subaru... • Answered on Jun 24, 2013
Not finding what you are looking for?
1990 Subaru Legacy Logo

338 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Subaru Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Oliver Street

Level 2 Expert

73 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Legacy Subaru

  • Legacy Subaru

Most Popular Question

high

  • Cars & Trucks
Loading...