have no power at either field wire at alternator, when alternator fields are connected and key turned on the guage fuse blows...
does the pcm control the field circuit? is there a diagram available
well yes there is a diagram available if someone just knew exactly which jeep model you have and the engine and transsmission combination.Here is what I have available Hope it helps if I can do anything more to help please let me know. also check under the battery I have seen corroded wiring many times I thank you for your question and if I have helped you please give me a fixya! Rating Thanks, Randy
www.aceautomotive1.com
Posted on Aug 21, 2008
have done the following:
disconnnected blower hooked directly to battery works fine
with test lamp no power to bloser switch
with test lamp no power to fuse block with fuse removed no power to either post on post block
switched relay on power distribution center
It sounds like you have an issue with your fuse block. Pull the fuse for the radio and remove the buzzer. see if this changes the situation.
Posted on Nov 15, 2008
I have looked at fusebox but it does not look like any blown...everything works but tail light anddash light
94 jeep cherokee
this is a fuse I honestly believe check them with ohm meter. Lots of cars if you have a tail light out the dash light will not function also. I hope this helps
Posted on Dec 18, 2008
hi need to find picture of 1994 jeep cherokee fuse box diagram thanks
the 2nd box is to the left of the brake pedal mounted to the fire wall.... I NEED A DIAGRAM!!
Posted on Jan 17, 2009
Leak at oil filter adapter . cannot loosen bolt holding oil filter adapter to replace o ring.They're afraid it can break in the block.94 jeep cherokee 4 liter. How do you loosen it without it snapping. If it snaps what do you do?
It is very hard to turn, but it will come loose, a cut off allen wrench attached to a pipe works great, as there is no clearance to do it any other way. Have at it cause the allen bolt is pretty hefty.
Posted on Apr 17, 2009
my 94 jeep cherokee clunks in the rear end after coming to a stop. when i hit the gas it will make a clunk noise like something is letting loose. when i was investigating i found that all abs relay's and fuses are missing from my relay box. O.K. WHY?
I don't have a solution yet but my 94 jeep cherokee does the very same thing. I thought it might be in the rear axile.
Posted on May 18, 2009
1994 jeep cherokee country wipers,turn signals,and ac/blower not working dont think there is power to them are these tied in to a fuse or linked toghter? thanks for any help
looks like they are on more than one fuse. your passenger compartment fuse box is down below your dash panel on drivers side between brake pedal and left side kick panel. the heater a/c fuse is a 25 amp fuse, should be fuse 6. the wipers are fed through a 4.8 amp circuit breaker which might be in the same fuse box, or not. your car also has a power distribution center under the hood. if you don't get anywhere with the fuses in the passenger compartment, look in the power distribution center. chrysler doesn't always share lots of info and i can only look up part of the wiring diagram. can't find anything about turn signals, my guess is that fuse is in power distribution box. hope that helps
Posted on May 31, 2009
i need a fuse box diagram for a 1995 jeep grand cherokee laredo the cover has no diagram attached
I have the same model Grand Cherokee Limited 5.2L V8, nice truck; for fuse panel description and locations, check page 7 and next. All the infor that you need is here: Jeep-ZJ-Grand Cherokee-Secc-8W-Wiring-Diagrams.
Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.
Thank you for using FixYa, have a nice day.
Posted on Aug 22, 2012
clicking noise in transmission when accelerating, the noise comes and goes. what is it?
Double check.Is it coming from the transmission.A clicking noise under load may be a universal joint in the driveline or a c.v. joint in the front end.Both are cheaper than a trans.Check these 1st.Hope this helps
Posted on Aug 24, 2009
When I try to use the power mirrors the fuse blows.
A common problem with a short in the mirror circuit is the wiring that comes from the body to the door. When you open the door you will see a wire loom between the door hinges. If the fuse blows when attempting to adjust either mirror it would be on the drivers side. If the fuse blows only when adjusting the right mirror check the loom on the passenger side. From bending back and forth it is common that one or more of the wires in the loom have broken and possible shorted together. That would be the first place I would start to look to find this problem.
Posted on Nov 06, 2009
332 questions posted
Usually answered in minutes!
1,380 Questions
1,162 Questions
698 Questions
672 Questions
659 Questions