1994 Honda Accord - Page 6 - Answered Questions & Fixed issues
Why will my 1994 Honda Accord not start in hot weather?
Do you get an error code? Try running a scan on it with a borrowed OBDII tester or one at a local repair shop (tell them you ONLY want the CODE, not the work).
If no error code, has anyone bypassed any of the evaporative emissions equipment? The charcoal canister, especially? If you get too much fuel vapor in the canister, it may flood the engine.
Does the car have the correct gas cap? That's important, because the cap is an integral part of the evaporative emission system, and the wrong cap may not permit fuel vapor from the tank to charge the charcoal canister correctly. Try opening the gas cap for a moment, then reclosing it, on a hot day just before trying to start the car to see if that helps.
Last, check (or have checked) the fuel pressure and flow rate AT the FUEL RAIL on the engine. There's a tap on the fuel rail where you can attach a fuel pressure gauge; you can use the same tap to check flow rate. Your fuel pump may be ready to die...
4/10/2016 5:54:26 AM •
1994 Honda...
•
Answered
on Apr 10, 2016
•
130 views
1994 honda accord no start and no spark
First, I would check your wires to and from the distributor. If they are all good and connected, I would move on to the spark plugs. Make sure they are gapped correctly. (.035" or 1.1mm)
If those are all good, you may need to replace your ignition coil (The big box thing the shortest wire from your distributor goes to) It may be pricey, but that may be your problem!
7/14/2014 6:42:39 AM •
1994 Honda...
•
Answered
on Jul 14, 2014
•
824 views
Why is my brakelight on?
The brake light switch is located just above the brake pedal. Take a look at it and see if it is broken or loose.
7/5/2014 9:19:53 PM •
1994 Honda...
•
Answered
on Jul 05, 2014
•
38 views
1991 honda accord wagon why the doors lock but dont unlock
Could use a little more information about the car like manual or power locks. Will they unlock from the switch on either door? I'll assume power locks. The most likely culprit would be the door lock actuators. The parts are inexpensive, but the labor is not.
7/5/2014 4:35:47 AM •
1994 Honda...
•
Answered
on Jul 05, 2014
•
256 views
Check power steering fluid in honda accord 1994
The power steering reservoir (I believe) is on the drivers side just behind the headlight. about mid-way down the side of the reservoir are a high and low mark. The reservoir should be just at or below the high mark when the vehicle is off. ONLY USE HONDA POWER STEERING FLUID. There are certain conditioners and additives in the Honda fluid that keep seals in the system in good condition. Using a generic/aftermarket fluid will cause the seals to shrink and the system will likely develop leaks.
7/3/2014 12:06:21 PM •
1994 Honda...
•
Answered
on Jul 03, 2014
•
209 views
Car shakes when braking at high speed
The front brake rotors need to be turned or replaced. If they've never been turned before, any dealer can easily fix this problem. On Honda Accords, they turn the rotors while they are sill torqued onto the hub.
Over time, the rotors heating up and cooling down leads to slight warps in the rotor. If it is warped rotors, the pedal will pulsate worse when you're going pretty fast and apply light pressure on the pedal.
A Honda dealer is the only place I would reccomend having this work done.
7/3/2014 6:28:12 AM •
1994 Honda...
•
Answered
on Jul 03, 2014
•
113 views
What could be causing the front turn signals to not work?
Hi, it sounds like bad wiring like you say, you're gonna have to get rid of all the add on stuff, cause the way I see it, it might requiere a higher capacity fuse, the down side is you leave your computer more expose to electric damage and/or a short circuit leading to a fire (dangerous). Best solution is... get rid of all that stuff and if you feel it's best, re-wire.
6/11/2014 1:09:13 AM •
1994 Honda...
•
Answered
on Jun 11, 2014
•
51 views
Auto electrical troubleshooting
Probably a poor alarm install. Look under the dash and see if any cheap connectors are installed. Then show that to the dealer.
5/18/2014 1:58:23 AM •
1994 Honda...
•
Answered
on May 18, 2014
•
71 views
I have a honda accord coupe 94 the clutch stops workin after i start the car i ihe car doest accelerates
If you mean you step on the clutch, put transmission in gear and release clutch with no engagement (pedal returns to top position) there is a good chance your clutch disc or pressure plate, or both are worn out and need replacing.
If your clutch pedal is going to the floor and not returning there could be a leak in the system, a bad clutch master cylinder or a bad slave cylinder on the transmission. Check the fluid level in the clutch master cylinder. If it is low or empty you have a leak or component failure. Visually inspect clutch master, line, slave cylinder for fluid leaks. replace as needed. If hydraulics are o.k., suspect clutch disc/pressure plate.
5/9/2014 1:11:02 AM •
1994 Honda...
•
Answered
on May 09, 2014
•
253 views
The fuel gage is broken what is the cost to replace?
hi fuel level sensor is in the gas tank part of the fuel pump before changing it u should verify the wire harness going to the fuel pump if its not a cut or broken wire if the fuel level wire is grounded with a 12 volt test lamp on ground the level in the dash will mark full to make sure u r gauge is functional danny
5/3/2014 3:59:05 AM •
1994 Honda...
•
Answered
on May 03, 2014
•
73 views
CAR DIED WHEN TURNED ON AC
It sounds like the over heating problem might be a blown head gasket dose the motor oil have water in it or water have oil in it .and the ac sounds like the clutch on the ac unit is bad i had the same car and it did the same thing and the belt on the ac did not brake the motor just dies
4/16/2014 9:37:27 PM •
1994 Honda...
•
Answered
on Apr 16, 2014
•
84 views
How do i align this car D I Y
You don't. You probably bent some suspension components and the steering geometry is not correct. This can be dangerous. Take it to a shop and let them have a look.
4/13/2014 11:25:09 PM •
1994 Honda...
•
Answered
on Apr 13, 2014
•
56 views
Turn signals not working
Typically the turn signal circuit starts at a fuse then goes through a flasher. From the flasher it goes to the turn signal switch where it is routed to the appropriate bulbs.
There are some cues as to where to start looking. If the bulbs light up on the car and/or the dash than the flasher is most likely the problem. If nothing lights up it could still be the flasher but it could also be a fuse. I’m happy to assist further over the phone at
https://www.6ya.com/expert/jeremy_d728a59f986299fa
4/11/2014 9:30:35 PM •
1994 Honda...
•
Answered
on Apr 11, 2014
•
94 views
Not finding what you are looking for?