20 Most Recent 2004 Volvo S80 Questions & Answers

Possible damage to one of the ABS sensors when the axles were removed to replace the transmission. Or one of the sensors is disconnected or not tightened down.

To get appropriate service, take it to a Volvo dealer or a Volvo specialist.

Your pvc or so called oil trapp is plugged replace that and look at the engine where it goes in for blockage too that's the problem Regards Chris

Check your fuse in the drivers side dash with the door open it's right there thanx Chris

Undo the nut & pull arm off then fit new arm, if replacing the motor you need to remove bumber

Car on, add thru low side, ( blue, ), check temp

flash confirms that the car is fully locked. Check if all doors are closed and if didn't disabled alarm.

PULL THE HOSE LOSE FROM THE PUMP. IF ITS PUMPING THEN THE LINES ARE STOPPED UP. IF NOT PUMPING THEN YOU NEED A PUMP

Possibly the light that illuminates the gear position indicator on cars with automatic gearboxes?

is it red or amber

After you replace the module (under the console), reset with an Autel European ODB (EODB) scanner.

It's attached to the washer bottle.

It is behind the glove box and under the hood in front of brake master cylinder.

Hello. If you have a impact gun it will spin off , if not you can use a pair of vise grips and a leather glove. Put the glove around the pully and pinch it with the vise grips. This will help you keep from bending or putting nicking up the pully. Then just turn the bolt until the vise grips hit the side of the housing and you should be able to break it lose.

If it's the approach light under the mirror, the lens pops out to replace the bulb. If it's the turn signal bulb, then the mirror cover has to come off

Takes three things to make engine run gas,air, and compression. Plug code reader in get codes ..

Tell us about what has been tested so far, how it was done & the results