20 Most Recent 2000 Volvo V40 Questions & Answers

check for relay for that light and possible ground wire problem

Still think ot vacuum related .This will push the revs up sky high .Get a good cigar and pulloff a vacum pipe .Take a good puff on the cigar now puff the emoke down the vaccum pipe .Now do you know what your looking for .You got it ,,, smoke ,,,,than you have found the leak.Thats if you have one ..Can you get a obd check it will tell you what it is ..Thermostat removal wont change the engine revs

I have the same issue and when I unscrewed the drivers side sun visor I didn't realize it was connected to wires. I unfortunately pulled about 3-4 inches of the wire out unknowingly but I realized that when the radio stopped working so don't do what I did ok? Did you ever find a way to keep the visors in place?

Hello Hogg_Dave Sounds smart...! Beyond my first & favorite recommendation: Beg, buy or borrow the MANUFACTURER'S FACTORY WORKSHOP REPAIR Manual(s)... Seriously... & yes I know the cost of some of them For USA market vehicles... FREE drawings & TECHNICA SERVICE BULLETINS at the BBB Industries website.. (registration is required as these are real documents) BBB Industries Premium Alternators Starters Power Steering Products

Remove turn signal. Loosen screws mounting bumper to front mudguard. Shift the bumper slightly to front/down. Headlight will probably go out (after unscrewing with 10 mm wrench).

Wiper switch is bad not the motor.

petrol or diesel ?

this is a renault engine and the marks are on the timing belt but the bottom mark is down at 180? and the top cam mark is at o? the belt has white lines on it when new and these all line up .simple

What about it? Its the one behind the catalytic converter. The heaters fail alot and require sensor replacement. 22mm wrench.

You need a new transmission.

If you are talking about the cables sparking when you connect or disconnect them then yes that is normal.

If it is just in one side . Lift it and check it . If nothing . On wheel . It may be your universal join. That's what it sound to me. Calipers make your wheels to burn.

1.Remove radio from central console. 2.Note the serial number from a sticker on a housing. 3.Contact nearest dealer to get the code.

If that is the T5 Engine you are going to need a Special set of Tools that hold the Cams, Sprockets and Crankshaft before starting on the seals if you are going to separate the Cam Cover from the Cyl. Head. I have done it with out the Tools but I do not recommend it. The PCV System you will have to pull the Injector Rail and the Intake Manifold to get to it.

Every volvo V40 vehicle has it's own code for the radio.

You will need to talk to a volvo dealer to get the code for your radio and hope they have kept the records in their system that far back.

You have low oil pressure. Remove the oil pan and replace all the internal and external orings

It should be on the end of the Fuel Rail feeding the Injectors.

I would start with the fuse Box .