Top 20 1991 Volvo 940 - Page 9 Questions & Answers

If your 2007 Volvo S80 3.2 is not starting after being involved in an accident, there could be a number of issues that need to be addressed. Here are a few things to check:

1. Ignition switch: The ignition switch is responsible for sending power to the starter motor and other electrical components. If the switch is damaged or not working properly, the engine will not start.
2. Battery: After an accident, the battery may have been damaged or disconnected. Check to make sure the battery is fully charged and connected properly.
3. Fuel system: The fuel system may have been damaged in the accident, preventing fuel from reaching the engine. Check the fuel pump, fuel filter, and fuel pressure to make sure they are working properly.
4. Starter motor: The starter motor is responsible for turning the engine over when the key is turned. If the starter motor is damaged, the engine will not start.
5. Shut-off switch: Some Volvo models have a shutoff switch that is triggered in the event of an accident to prevent the engine from starting. This switch may have been triggered and needs to be reset.
6. Key fob: The key fob needs to be in the car for the car to start. If the key fob won't come out of the ignition, it may be that the key fob is jammed inside the ignition and needs to be pulled out.

It's very likely that the shutoff switch is the cause of the problem, as you suspected. You should check your car's owner manual or contact a Volvo dealership or a professional mechanic to help you locate the shut-off switch and check if it is the cause of the problem. It's also possible that the accident caused multiple issues and it's best to have the car properly inspected by a professional.

Front and Rear Fog Lights? Fuse 3 okay? https://www.autogenius.info/volvo-740-1987-fuse-box-diagram/ Pull switch out and test continuity with a multimeter. The light may work, but the power out may not. And there is a relay involved as well https://www.google.com/search?q=1987+volvo+740+fog+lights+not+working ..

If you are experiencing unresponsive driver side power seat controls and an SRS (Supplemental Restraint System) airbag warning message on your 2008 Volvo S40 2.4i, it could be caused by a few different issues, such as:

1. Faulty seat control module: The seat control module is responsible for controlling the power seat functions. If it is faulty, the seat controls may not work and the airbag warning message may appear.
2. Wiring issue: A damaged or corroded wire connection can cause the seat controls to become unresponsive and the airbag warning message to appear.
3. Sensors issue: The seat and airbag system rely on a variety of sensors to function properly. If any of these sensors are malfunctioning, it can cause the seat controls to become unresponsive and the airbag warning message to appear.
4. Airbag module: The airbag module is responsible for controlling the airbags in the vehicle. If it is faulty, the airbag warning message will appear.

It's best to have a professional technician diagnose the problem and recommend the appropriate course of action. Sometimes, the problem can be solved by replacing a faulty module, repairing or replacing damaged wiring or sensors, but in some cases the repair may be more complex. It's important to note that the airbag warning light should be taken seriously and repaired as soon as possible, as it can indicate a problem with the airbag system that could affect the safety of the vehicle in case of a collision.

HI hOLLY no country told, the books are sold a the dealer. by year and VIN the online book may be good too. https://eautorepair.net/Marketing/Default.asp

The Transmission Control Module (TCM) on a Volvo XC90 AWD 2.9 is located under the driver's side dash, attached to the underside of the steering column. It is mounted behind the steering wheel and can be accessed by removing the lower dashboard panel.

TRUNK = BOOT, = UK. JUNK IN LOCK (LOOK) OR LOCK BAD.

no engine told at all and is a 100% engine EFI questions. NO VIN told and I tell you what is under the hood, no country told but VIN covers that too. sadly there is only generic answers. guess #1 gasoline , not diesel. engines die for over 50 causes,. we do tests to find them. here is list of many, fuel pump is only 1. no tuneups done for 18 years, a hopeless bit of abuse.??? spark parts, filters all, belts. fluids, etc. cam belt slipped, never serviced for 60 to 100k miles BOOM bad all 3 engines used in USA version have this belt, that must never be ignored, other pistons bend the heave valves over. horror. bad spark, the ECU sees spark dead it cuts fuel, fuel pump be danged. and last is fueling, never first , above is first what I do is check cam timing first not make it worse cranking. . world wide list, 1,984 cc (2.0 L) B5204T5 turbo I5 2,319 cc (2.3 L) B5234T3 turbo I5 2,435 cc (2.4 L) B5244S/S2 I5 2,435 cc (2.4 L) B5244SG I5 (petrol / LPG / CNG) 2,435 cc (2.4 L) B5244T/T3/T5 turbo I5 2,521 cc (2.5 L) B5254T2/T2-R turbo I5 2,435 cc (2.4 L) D5244T turbodiesel I5

The remote keyless entry (RKE) module for a 2010 Volvo S80 V6 is typically located in the trunk of the vehicle, near the spare tire. It is a small module that is responsible for controlling the functions of the remote keyless entry system, such as locking and unlocking the doors, activating the alarm, and starting the engine using the remote. To locate the RKE module, you may need to remove the trim panel or carpeting in the trunk. If you are unable to find the module or are unsure of its location, you may want to consult your owner's manual or a repair manual for your specific model of Volvo S80. Alternatively, you can try contacting a Volvo dealership or a mechanic for assistance.

Not a good idea having your email address as your display name rather than 'Jan Hayden'. The site has 11 million views a year, of which 1 million are spammers and marketers. Lots of help here and it appears to be a known issue https://www.google.com/search?q=1991+Volvo+740+not+getting+gas+hard+to+start

I answered this a couple of hours ago, you must have deleted it? https://www.fixya.com/users/norbert-64260 The answer is no. The pump has specs for pressure and delivery for that vehicle. The pump is cooled and lubricated by the fuel in the tank. The pump is monitored by the ECM (engine computer) for performance and pressure. Remove the back seat and replace the pump the right way, it is a lot easier.

And a third car you are working on today, Volkswagen City, and Oldsmobile Alero. Are you a mobile self employed mechanic with no clue :>D First check the fuse for the blower, the climate control and the body control module.

Volvo XC60 (2009-2012) fuses and relays

https://fuse-box.info > volvo > volvo-xc60-2009-2012-... Here you will find fuse box diagrams of Volvo XC60 2009, 2010, 2011 and 2012, get information about the location of the fuse panels inside the car, ...

Volvo XC60 (2010) - fuse box diagram - Auto Genius

https://www.autogenius.info > volvo-xc60-2010-fuse-b... Apr 1, 2017 - Volvo XC60 (2010) - fuse box diagram · Fuses - engine compartment · Fuses - glove compartment · Fuses - cargo area · Module A (black) · Module B ( ...

It is this whole assembly called the Central Electric Module:

Hi, Codes like these can usually be found within the troubleshooting section of your car manual. Please start by looking for the procedure to overcome the error there. Please take note of whether the error comes on after you've accidentally performed a certain action in your vehicle (ie removing seat belt, winding down windows etc). Thank you.

Question edited for clarity https://www.google.com/search?q=2001+Volvo+V70+Cross+Country.+PCM+location ..

One very common issue with these generations of 5 cylinder engines are the PCV system. If you haven't had the service completed yet, I'm sure it need it.

codes are OBDll and are available on line free. there should be a P0 inf ront of code here is a link to P0145 https://www.yourmechanic.com/article/p0146-obd-ii-trouble-code-o2-sensor-circuit-no-activity-detected-bank-1-sensor-3-by-jay-safford

NO CAR TOLD, OR IS THIS A TRUCK D13 a complex diesel engine. 375 horsepower and 1,450 lb-ft of torque.! those DTC codes are power train, not just the engine. so no car told https://eautorepair.net/Marketing/Default.asp P1 ,p2 codes are volvo only codes. factory codes , P0 xyz codes are what we call federal codes and are standard. $92,000 SEMI TRUCK AND YOU CAN'T DO A SHOP VISIT? Buy the service manual . the service manual only covers this truck and unique DTC codes !

NO COUNTRY TOLD AT ALL! BUT OURS IS HERE. (N.AMERICA) https://eautorepair.net/Marketing/Default.asp