20 Most Recent 1993 Cadillac Eldorado - Page 7 Questions & Answers

places to check are under glove box , and or both fender walls of engine compartment, look inside any large relay cover boxes labeled fuses and relays...look for a 4 pin small box shaped unit about 1 inch square or so...

the electric pull down motor has gone bad and if I remeber correctly that motor is an integrate part of the latch assembly. Cple bolts and amn electrical connector and the repair is made. take about 25030 minutes or less depending on skill level.

Is it smoke or steam thats coming out the tail pipe? Are you loosing coolant or overheating? It sounds like a classic head gasket problem to me. If it smells like gas it may be a bad FPR and what you are seeing is unburnt fuel vapour. If that is the problem, it is a cheap and simple fix.if not it might be head gasket problem only

The thermostat is located on the engine side of the upper radiator hose.

http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&ssPageName=STRK:MESELX:IT&item=250436705625

Check your motor mounts !

Water (coolant) level is probably low, or it has air in the system.

ok it can be a few things spark gas does the car turn over? when you turn on the key do you hear the gas pump prime? if its the starter there are a few things that you can do do you hear it click? you can try to take a screw driver and manualy start it by putting it across the main cable and the smaller one that is on the back of the starter this will let you know if the starter is bad without taking it out. now if it works that means your starter isnt getting enough power to check this take jumper cables from the batery and conect it to your starter then try your car. if this dosnt solve the problem post every thing that you hear see and what the car does.

In park all the way? Battery weak? The starter takes more power than anything else, so your headlights working doesn't tell you much. Your battery can be pretty weak and they will still come on. Have you tryed boosting it?

VSS CLUTCH ( 39 ) in the transmission. Basically its only mission to is to lower engine RPM's at the same time increasing fuel mileage. Hope this helps

Check for proper operation and power at brake light switch located at the brake pedal under L/S dash. Hope this helps

The Fuel Filter is located: Under vehicle, driver side, below seating area, driver side of fuel tank, mounted on frame in fuel line.

Here is the replacement procedure. Hope this helps
Lefty64

WARNING Fuel supply lines on all vehicles equipped with fuel injected engines will remain pressurized for long periods after engine shutdown. The pressure must be relieved before servicing these fuel systems.

1. Disconnect the negative battery cable.
2. Depressurize the fuel system.
3. Remove the filter bracket retainer.
4. For plastic type fittings:
   1. Grasp the filter and one fuel line fitting. Twist the quick connect fitting 1 / 4 turn in each direction to loosen any dirt within the fitting. Repeat for the other fuel line fitting.
   2. Squeeze the plastic retainer release tabs and pull the connection apart. Repeat for the other fitting.
   
   
5. For metal type fittings:
   1. Use a fuel pipe quick-connect separator J37088 or equivalent. This is available from your local parts store.
   2. Insert the tool into the female side of the connector, then push inward to release locking tabs. Pull the connection apart.
   
   

clutch problem with the compressor.Check drive pulley runs free when turned off and when you switch it on it should be tight.You have to remove the drive belt to do this.

Sounds like either a MAP sensor or TPS or both. TPS will impact the throttle control and if its stalling once its warm, this would be where I'd look. Best of luck.
Greg

Have you checked the battery voltage. It sound like your battery is almost completely dead. I would check that first.

Replace ignition lock cylinder and chip key. The wires have broken.

I know the problem, u must replace the auto pull down as an assembly, very common problem.

your shocks maybe leaking, have a tire shop take a look.

The A/C CONDENSER does not have to be removed in order to replace the RADIATOR, Just take off radiator hold down cover, hose, lines and remove . Hope this helps