20 Most Recent
2003 Honda S2000 Questions & Answers
Honda S2000 engine installed in kit car. How do I wire alternator
Unfortunately the Honda alternator is regulated by the ECU, which allows the ECU to intelligently reduce alternator engine loading to improve fuel consumption. The intelligent system uses an electrical load detector (ELD) located near the battery to control the alternator output voltage. A two wire alternator has an inbuilt regulator that will always generate the required charging voltage. When a battery is fully charged and the electrical loading is low there is no need for generating the charging voltage, in this situation the honda alternator will reduce the output voltage to reduce engine loading, hence improved fuel economy.
The passanger side window and
Check the window lock out rocker on the driver side door for the passenger window. The hand brake must be on for the roof to operate.
No clutch peddel. will go in gear and pull if eng
check that there is fluid in teh clutch reservoir under the hood.
if you pop hte hood on the drivers side (right side) of the engine in the back right corner of the engine bay you will see two fluid reservoirs each wwith a grey cap. the one closer to the front of hte car is the brake fluid, behind it is for the clutch. It should be filled between the min and max lines printed on teh side. you fill the reservoir with dot3 brake fluid. It is important that you don't let any contaminates or water get into the fluid so most people try to use a fresh botle every time they top it off.
after that you really should have yoru ****** fluid changed or at least inspected for proper fill amount. I’m happy to assist further over the phone at
https://www.6ya.com/expert/jeremy_cd01d4e4178e5a11
I need to know all the steps to replace a
http://www.alldatadiy.com/alldata/AFI~V16394790~C35707~R0~OD~N/0/80851247/84820120/84820190/84820352/34853741/34867926/34868471/34868577
copy and paste ,hope this helps
Not finding what you are looking for?