1992 Honda Prelude - Answered Questions & Fixed issues

When the light comes on, a trouble code is stored in the computer. There are well over 800 possible trouble codes. Get the trouble code and then you'll know

High resistance in wires or plugs can cause you to burn through cap and rotor

Strange problems such as what you have described are usually caused by a poor ground connections. Without a manufacturer wiring diagram you are going to have a hard time locating where these ground connections are. There can often be ground connections in the wiring harness connectors. What you can try is to remove the negative battery terminal from the battery and to connect an ohmmeter to the negative of the battery and then check suspected ground points.

Honda Prelude Service Repair Manual 1992 1993 1994 1995 for easy and best solution visit this link

1342

If you are DIY, I highly recommend the repair manual, with the electrical section. filepeep.com if they have it. or, manualslib.com or auto parts store usually carry it. or your library may carry a copy.

YOU NEED TO HOOK UP A SCANNER AT AUTOZONE FOR FREE. THEY LET YOU BORROW ONE OR THEY'LL DO IT FOR FREE FOR YOU. THEN READ THE CODES, OF WHATS CAUSING YOUR PROBLEM. WRITE THEM DOWN SEND THEN BACK. DELETE THE CODE AND RESET THE LIGHT ALSO. RUN IT AND SEND YOUR CODES HERE IF YOU LIKE ....IF YOU TAKE IT TO A SHOP THEY CHARGE JUST TO CHECK THE CODES. HOPE THIS HELPS AND DONT FORGET TO SEND A FEEDBACK THANSK

Transmission could be running hot. Most times tranny fluid also runs through the sides of the radiator. Or a transmission cooler somewhere near the radiator and in some cases will make temp gauge rise

interior air filtering and air conditioning is there

There should be no water going to the transmission.

If it is an automatic, there is a dipstick to check the level. If it is a manual you have to take out the fill plug to see if the oil is up to the correct level.

here is a u-tube video with a good tip for making sure the timing marks dont get move once set may help How to replace timing belt on Honda Prelude 92 96 2 3 lt H23a1

Look under dash at the top of your brake pedal. See the button switch, that the pedal pushes in. Push in and out by hand a few times. Put a dab of oil on your finger, put on button, and push in a few times by hand

Are you seeing an actual leak on the ground, or are you just having to add coolant ?

old parts? if you want to wire in something old, the post the name of that,and its full part/number, and model name. and year if the sticker shows that. new infintant players. does Hook up mean wire in a new head in to the dash? or just plugging something in a the cars AUX jack. we dont know.

This should sort you out - http://www.honda-prelude.com/downloads/literature

If you are hearing a clicking sound but the engine is not cranking you may have a bad connection on one or both of your battery cables. If your cables check out good then your starter may need replacing.

Just because the battery was "charged" doesn't mean it is a good battery, remove it and have a local discount auto parts store test it, it is free.

Hard to say without looking at it. Usually it is 2 reasons: the bulb is not fitted properly or the headlight itself is dull (yellow). In the second case you just polish the headlight with some car polish until it is clear. Anyway i am sure you fixed it by now....

1st google hit http://www.clublexus.com/forums/es300-and-es330/603269-2004-es330-key-replacement-story.html