20 Most Recent 1992 Honda Prelude - Page 2 Questions & Answers

This should sort you out - http://www.honda-prelude.com/downloads/literature

If you are hearing a clicking sound but the engine is not cranking you may have a bad connection on one or both of your battery cables. If your cables check out good then your starter may need replacing.

Just because the battery was "charged" doesn't mean it is a good battery, remove it and have a local discount auto parts store test it, it is free.

Hard to say without looking at it. Usually it is 2 reasons: the bulb is not fitted properly or the headlight itself is dull (yellow). In the second case you just polish the headlight with some car polish until it is clear. Anyway i am sure you fixed it by now....

1st google hit http://www.clublexus.com/forums/es300-and-es330/603269-2004-es330-key-replacement-story.html

AIR vacuum fuel vents A/t cooler P/s fluid lines. water. what? no matter log in to alldata.com its there.

Automatic or manual? Need more information. Automatic for this model should be no more than 3 quarts of Honda DW1 ATF. Manual should be no more than 2 quarts of Honda MTF.

Do you have power and a ground signal going to the coil ?Could be the distributor or the igniter module.

maybe a fuel pump thats weak and going out... like only turning on some times instead of all the time

blown head gasket would prolly be the issue... and its sounds bad..when the head gasket blows the water and antifreeze passes thru the gasket into the cylinder and if enough water goes into multiple cylinders... then yes it will shake like crazycheck the exhaust to see if water is in it

Check fuses

Sounds like a bad ECU. Why did you change motors?

This is a fault code in the trans. One solution is ti disconnect tge bsttery fir 10 to 15 minutes this will reset the trans. Control unit. If thus does not work it could need a rebuild.

Hi Joe, You have to remove the complete knuckle assembly from the car, on the back side where the axle goes trough the bearing, you will notice 4, 12 point bolts, you need to remove these bolts first then press the bearing out of the knuckle assembly. The job is quite a large job and would take a professional about 2 hours with the right tools. I'm not saying that to scare you, but to warn you. Let me know if that helps Joe.

when you installed your timing belt did you make sure all the marks on your pulley and cam where lined up also need to make sure no valves bent in the head.

This could be caused by a wiring mistake when the alarm was put on. yes it can be something to do with your alarm.

Hello,

I understand being new to cars, but that is ok. I am hear to help you. Some cars run hot, that is normal in a lot of cars. As long as it does not go into the red or way over the half way point your ok. But this is what I would do, this will make sure that car water temp/engine temp is working properly. First of all check your engine oil and make sure it is full at the dip stick. And then do the same with your radiator, make sure it is full with antifreeze. Also, you can have the antifreeze checked, they can test it, to make sure the right mixture of antifreeze and water are proper mixture. If not enough antifreeze compared to water ratio is off, then that can cause some over heating or possible over heating issues. So, in conclusion: first things to check is engine oil level and antifreeze level and mixture. I hope this helps you, thanks mike, expert fix ya man.

I suggest read this information about Prelude 1992 to 1995 - Radio Installation / Stereo Installation HERE.Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.Thank you for using FixYa, have a nice day.