Top 20
2002 Cadillac Seville Questions & Answers
No air flow for heat and A/C
It would be unlikely that a heater core - a/c blower would be running or supposed to run a 30amp fuse, a 10 amp would be sufficient for that curcuit, or it could overheat the wiring in a fault.
Trace the wiring back, check for power from the fuse and trace it down to the fan, to check the fan run power into it and see if it operates.
Check the fan resistor.
My cadillac saville sts 2002 changed battery wont start now not cranking
This may be related to the antitheft system The system is known for turning off the starter and/or injectors when it fails. Normally when the injectors are turned off, the car will run for a second or two, and then stall. Is there a light on the dash that says SECURITY or a picture of a car with a lock through it? This is a common problem worth looking into. http://www.diy-gm-security.com/
2002 Seville won't start with key but will start with remote
This may be related to the antitheft system. The remote start bypasses this system so the vehicle will start without reading the key. You have a failing secuirty system. The system is known for turning off the starter and/or injectors when it fails. Normally when the injectors are turned off, the car will run for a second or two, and then stall. When it's the security locked out starter, you won't even hear a click when you turn the key. Is there a light on the dash that says SECURITY or a picture of a car with a lock through it? This is a common problem worth looking into.
Do It Yourself GM Security bypass
What needs to be done when the car says it needs to change engine oil
Your car has a specified change engine oil system..it is based on recommended miles buy the manufacturers..it is not critical that you immediacy chage the oil..a lot of things determine that..one is how you drive,where you drive if you drive only highway miles in a clean enviorment could be longer..in a dirty air enviornm or in daily stop and go city traffic could be shorter...you know the conditions so use that as your change oil time or simply follow the cars signal to change..good luvk
Why my 2002 cadillac seville sls will not idle
Get one of the neighborhood kids to hold the accelerator pedal down for you...RALOL! Just kidding.
Since I don't know what your automotive skill level is or what diagnostic tools you have, I would first have to ask you- is the "check engine" light on?
Perhaps you can borrow an OBD reader from a neighbor, friend, or relative that has one? or perhaps renting one out from your local auto part store? Sometimes the counterman may have one readily available and will check for any fault codes for you.
It's possible that you may have a problem with the mass air flow sensor or a leak in the mass air flow duct leading to the throttle body or a faulty Crank or cam shaft positioning sensor or anything else in between. Unfortunately, without a code reader to guide you to the source- it would be guess work.
Where is spark plug # 8 located?
if this is a transverse engine #8 is located at front of motor and to the left by the drivers side. if its a conventional set up then it is located on the drivers side at the rear by the fire wall.
Obd ii code 0336 seville
I've found three sites on the Internet that post the codes. I don't have links to them, but they're easy to find.
Battery temperature sensor
It could be either a bad battery or bad battery connections. Have the battery tested . Some auto parts stores will do this for free.check battery connections for signs of corrosion. Clean thoroughly before reinstalling battery. It may be a charging system problem have a garage test the alternator. Hope this helps
Change a fuel pump on my 2002 cadillac Seville
Hoping the gas tank is close to empty. The fuel pump module is located on top of fuel tank. Raise car in air support with jack stands remove necessary shields and exhaust piping. disconnect fuel lines and electrical wiring remove straps and lower on a floor jack. Once out clean road debris off top remove lock ring and remove module either replace as unit or pump by itself. Install in reverse order. Your first one about 3-4 hours shops 2-3 hours.
Not finding what you are looking for?