20 Most Recent
2002 Cadillac Eldorado - Page 7 Questions & Answers
Check engine light went on after oil change on 91
have code retrieve first . but look underhood if any connector are connect. specialy the MAT sensor on air cleaner. people check the air cleaner and disconnect the mat sensor . could be other sensor connector but have a look underhood.
10/4/2013 12:46:10 AM •
Cadillac...
•
Answered
on Oct 04, 2013
Have frost plug with pin hole leak, whats the best
Note how far the plug is recessed in its hole. You will want to tap in the new plug to the same depth.Use a hammer and small punch. Put the punch at the edge, not on the lip of plug, but out near the edge. Tap on it until it starts moving inward, the opposite side will be pushed out. Grab onto it with a pair of pliers and wiggle it out of the hole.Clean the recess of rust and dirt, place the new plug in and tap it in evenly to the depth of the old plug. It may help to use a socket that fits inside the plug as a driver to drive it in evenly.Keep an eye on the other freeze plugs. When one rusts through, others may follow. You should drain all the old coolant out, flush the engine and radiator, and put in new coolant, new thermostat too is a good idea. If rust is bad, consider a professional flush-they can do a much better job than a garden hose. Your radiator may need attention, too. Good luck.
10/3/2013 4:14:37 AM •
Cadillac...
•
Answered
on Oct 03, 2013
Set engine timing
make and model type year vechicle working on.the vechicle cant be timed if you has distributorless type ignition system PCM control ignition timing
9/9/2013 9:59:42 PM •
Cadillac...
•
Answered
on Sep 09, 2013
Top shock nut stud spins with nut and wont loosen
If you don't have access top an air gun or electric impact it's not easy. Look at the top of the strut and you will see that it either has a hole in it for an Allen wrench or it is cut for a wrench.With the Allen wrench type, slide a socket onto the nut and then put the Allen wrenchy in place. Turn the socket with a pair of Vice-Grips while you hold the Allen Wrench. A sharp snap should get it loose.If it has the wrench style end, usually a box end wrench will hold the shaft whilt you turn the nut with another wrench. Sometimes it will strip and you'll have to grab it with Vice-Grips.
8/12/2013 8:00:52 PM •
Cadillac...
•
Answered
on Aug 12, 2013
Northstar v8
have the fault codes read Look for a throttle position sensor fault or MAF sensor fault
7/17/2013 8:19:13 AM •
Cadillac...
•
Answered
on Jul 17, 2013
Turns off
Change the coolant temperature sensor, the one for the computer, not the one for the dash gauge.. And scan for trouble codes.
5/25/2013 9:20:46 AM •
Cadillac...
•
Answered
on May 25, 2013
Voltage drops idle
your battery is not grounded enough, add another ground wire from battery to a new clean and sanded to metal part of your firewall
5/24/2013 5:34:30 PM •
Cadillac...
•
Answered
on May 24, 2013
Often change timing belt
I don't know of an Eldorado that uses a belt. They use a timing chain.Cars that use a belt will not run when the belt breaks.
5/10/2013 12:09:42 AM •
Cadillac...
•
Answered
on May 10, 2013
Not finding what you are looking for?