Hi Ron, Connect the two cables to an analogue voltage test meter. Turn on the mili voltage scale and then pass something metal across the business end without touching it. and a slight movement should be recorded as a small voltage is generated. If nothing happens the unit is defective. Regards John

Read full answer

10/20/2013 2:24:07 PM • 2006 Subaru B9... • Answered on Oct 20, 2013

0answers

2007 subaru tribeca codes a p0705 and flashes

Read full answer

Be the first to answer 10/8/2013 8:13:48 PM • 2006 Subaru B9... • Posted on Oct 08, 2013 • Be the first to answer

0helpful

3answers

Subaru Tribeca 2006; the radio stopped working the

had the same problem. no radio, navigation interior lights etc. replaced 20 amp fuse labeled "back up" in the engine compartment fuse box and all checks good.

Read full answer

9/17/2013 11:19:51 PM • 2006 Subaru B9... • Answered on Sep 17, 2013

0answers

Replace starter 2006 TRIBECA

Read full answer

Be the first to answer 9/16/2013 11:08:42 AM • 2006 Subaru B9... • Posted on Sep 16, 2013 • Be the first to answer

0answers

Where is the starter on a 2006 Tribeca

Read full answer

Be the first to answer 9/16/2013 10:26:36 AM • 2006 Subaru B9... • Posted on Sep 16, 2013 • Be the first to answer

0answers

Shift solenoid p0761

Read full answer

Be the first to answer 8/30/2013 4:15:59 AM • 2006 Subaru B9... • Posted on Aug 30, 2013 • Be the first to answer

0helpful

1answer

I bought my 06 Beca with 118k on it 2&1/2 weeks

I am not familiar with the car, but is it a 4 wheel drive at all?If it is and its engaged that can cause a shake like that. I’m happy to assist further over the phone at https://www.6ya.com/expert/robert_54ae41aaaffbab00

Read full answer

8/23/2013 5:58:51 AM • 2006 Subaru B9... • Answered on Aug 23, 2013

manual

2006 B9 Tribeca Manual

Subaru Tribeca Cars & Trucks • Uploaded on Aug 04, 2013

0answers

2006 SUBARU TRIBECA NAVIGATION RADIO NOT WORKING

Read full answer

Be the first to answer 7/25/2013 8:12:07 PM • 2006 Subaru B9... • Posted on Jul 25, 2013 • Be the first to answer

0helpful

1answer

Warning lights

low on rear differential lubricant. it's getting hot.

Read full answer

6/26/2013 6:38:40 AM • 2006 Subaru B9... • Answered on Jun 26, 2013

0helpful

1answer

P0011

code p0011 refers to camshaft position(CMP) intake/left/front, bank-timing over advanced/system performance causes ---valve timing---engine mechanical fault--CMP actuator--- wiring I would be taking it to a dealer service department as if it is the cam actuator it will be part of the cam shaft and will require specialist knowledge for repair or replacement.. Also it may be covered by a recall notice or covered by warranty.

Read full answer

6/22/2013 9:14:26 AM • 2006 Subaru B9... • Answered on Jun 22, 2013

0answers

Check engine cruise control traction

Read full answer

Be the first to answer 5/10/2013 5:34:38 PM • 2006 Subaru B9... • Posted on May 10, 2013 • Be the first to answer

0helpful

2answers

I just needa serpentine belt diagram for a 2006 subaru tribeca

Diagram reference number 1 in the image below:

"" Fitment: 2006 SUBARU B9 TRIBECA - 4 doorApplication Notes: Category: Electrical. Charging and StartingSubCategory: Alternator / Generator and Related ComponentsPosition: GeneralPart Number: 809221090This is a Serpentine Belt that fits the 2006 SUBARU B9 TRIBECA - 4 door with the EZ30D engine. The Serpentine Belt is designed by SUBARU to be part of the Electrical. Charging and Starting-Alternator / Generator and Related Components. The Serpentine Belt has a position on the vehicle of General. The 2006 SUBARU B9 TRIBECA Serpentine Belt is a factory made SUBARU OEM part and it comes with a 12 month 12.000 mile warranty (parts only). Do not be fooled by an aftermarket SUBARU B9 TRIBECA Serpentine Belt! Buy a factory SUBARU part and receive peace of mind! This factory part has a part number of 809221090. "