20 Most Recent
2002 Subaru Outback - Page 9 Questions & Answers
Check engine light came on. What?
There could be many reasons for the check engine light coming on and I
believe the only way to tell what is going on is to plug into the
diagnostic port with a scanner and see what codes come up.
Tell us news.
Headlight burns out??
INFO:
Your alternator may be pushing higher voltage.
RECOMENDATION:
Have the alternator checked for high voltage. You can even measure it yourself with a voltmeter on the battery while car is running. it should be around 14.2.
Hope this tip helps.
R/
David
It was very cold this
Drive you vehicle to the nearest Auto Zone and they will do a FREE SCAN on your Outbacks computer. That will show what codes are causing the check engine light to come on. They will advise what is needed plus they can quote you prices on most anything for it too
The compass on my 2002 Subaru Outback is about 180
check for any sources of magnetism near the compass, speakers, phones, mobile phone accessories etc, there could be something in the glove box, empty the car of anything likely to have a magnet in it and check the compass again.
2003 subaru outback mirror glass replacement
You need some bathtub silicone sealer and some black electrical tape and a couple of small wooden blocks. Carefully break out the cracked mirror. WEAR gloves and glasses when you do this and have a bucket to catch the falling glass. Make sure the mirror back is clean and put a bead of silicone around the back of the new mirror. Keep it about 1/4 inch from the edge and some dabs in the center portion. Place the mirror on the back and tape one edge down using a wooden block for a spacer. Then do the other side. Make the tape snug so it squashes the silicone and leave the mirror alone for 24 hours. After that take the tape and blocks off and you are good to go. Hope this helps.
Cd player stopped working. Also want to hook up
Hi
Thanks for using FixYa. Please
hook up the remote wire and the power antenna wire to the blue factory amp
wire. This will let you hear the sound when cd is played. After the above step
is performed, then remove the detachable front panel. Behind the front panel,
to the right of the connector, there is a small hole. Using a ball-point pen or
other pointed object, press the RESET switch mounted behind this hole. This
will reset your system and you will be able to hear the sound again from CD.
To access the CD follow the
step-by-step procedure from the links---
Adding
Stereo to Subaru
Car Audio
Installation Instructions
Audio
Installation Guide
Please do
accept the solution if the issue is resolved or else revert for further
assistance.
Thanks
Rylee
Not finding what you are looking for?