1987 Honda Prelude - Page 8 - Answered Questions & Fixed issues
Switch on the drivers side
You need to replace that switch. It happens every now and then to some Hondas. I've seen a few at work. The switch is most likely broken internally. There is no repair for the inside of these switches. Maybe try the wreckers for a used part? The door panel is fairly easy to remove.
My blower worked day before
Switch on the blower motor and bang on it, if it starts then you might need a new motor. If it dosent then make sure you have power at the motor plug in wire, if you have power then its a bad ground.
I need the diagram for
Check your owners manual since many manuals include fuse diagrams. Also auto parts stores offer free assistance with repairs and are likely to have diagrams.
Abs light on dash lit
Before doing anything, check the brake fluid level. When the ABS indicator light comes on, an error has been detected in
the antilock brake system and you need a scan to find out what is
causing it.
Most parts stores provides the scanning
service either free or for a nominal fee. The code would be stored so need to retrieve it to know what component is causing it. Get the scan done and let us
know the exact trouble codes so we can provide you with the information
for the error.
Oil leak at the base
Try tightening the filter a little bit but over tighten it.If it still leaks then replace the filter because the seal on the filter is leaking.
I just washed the out
For a car to run it must have ignition, fuel and air (for combustion). each of these can be checked easily:
1) If you have a rubber glove or plastic bad, take off the to the distributor (from the coil) and hold it with the glove or plastic material about 1/4 inch from a piece of clear metal on the car body or engine (a bolt works). If it sparks the ignition is ok when you have someone crank over the engine.
2) take the top of the air cleaner off to see if you can confirm gasoline is being pumped when someone cranks the engine. Or, get some starter fluid and spray it into the air cleaner when it is cranked over by someone. If it starts and dies again it is either your fuel pump or it is out of gas. If the air cleaner is dirty try the above without it (replace if dirty).
If the above does not work it needs to be checked by a mechanic.
I have a p0420 code
420 is catalist efficiency below threshold. Bank 1. This could be caused by a leaking exhaust before the converter or that the converter itself is going bad.
QUI PEU M'AIDE JAI UN
Hi, please interpret you question in English so as to enable me read, understand and proffer a solution.....
I want to replace the
The procedure to replace the tail light is as follows:---
1) Open the trunk.
2) Push
the trunk fasteners in until it pops using a flathead screwdriver to remove the
lining and access the bulb sockets.
3) Remove the frame away from trunk and you will see the light bulb assembly.
4)Twist the bulb out of the assembly towards counter clock wise direction.It will come out.
5)To remove whole tail light assembly.Its connected with screws.Remove those screws and disconnect the wiring connector from its side and lift the tail light assembly out.
6)But if you want to only replace the bulb then no need to remove whole tail light assembly out.Just remove bulb and replace new bulb in reverse and install all parts in reverse.
--------------
This should help.Thanks.Helpmech.
ENGINE LIGHT COMES ON
Does it stay on??? All engine lights come on when you start the car...then go off. You need to give a bit more info.
Not finding what you are looking for?