20 Most Recent
1976 Cadillac Eldorado Questions & Answers
1976 cadillac eldorado won't start (cranks)
I have had the same problem, the relays inside the ECU are weak when the pump is worn, need to be replaced or used as a steering-signal for an external relay for fuel pumpS, there are two pumps. Also the MAP sensor probably are dried out and need to be replaced, its the small box with the black air hose to it.
I didn't mark the torsion bar when I took it out, how do I install it without the marks
jack the car right up with the wheels off the floor
install the torsion bar with the adjuster bolt unscrewed all the way off
fit the bar and lower the car back onto the floor so that all the weight is on the torsion bar
it should be sitting a bit low at this point
adjust up the adjuster bolt to when it sits level
if there is not enough adjustment the jack up the car again
let the adjuster right off an this time use a pipe wrench ( stiltsons ) to turn the bar against the stop plate a spline then insert it into the housing
this preloads the bar before any adjustment
lower the car and again adjust the bolt
EXTREME CARE AND VEHICLE STANDS SHOULD BE USED AS THE CAR COLLAPSING CAN CRUSH THE PERSON UNDERNEATH
How to remove the oil pan
First lift your car so you could get under it. Make sure that you have some device under the car to protect you just in case that the jack fails and the car falls on you. Then remove the screw from the oil pan. Have an oil recipient to ready to collect the oil output.
After that, you may have from 4 to 6 screws to remove. You need to find out the size of the head of the screws and use a ratchet to remove it.
Not finding what you are looking for?