20 Most Recent
1995 Audi A6 - Page 7 Questions & Answers
1995 Audi A6 engine problem
Check that the correct oil is in the gearbox - and in correct quantity. Sounds like there is too little oil in the converter.
6/14/2008 9:50:42 PM •
1995 Audi A6
•
Answered
on Jun 14, 2008
Oil pressure lamp
check and clean the connection on oil switch plug also try running an engine oil flush and changing the oil if that doesnt fix it then try removing the sump off the engine and cleaning the oil pick up
6/3/2008 3:08:03 AM •
1995 Audi A6
•
Answered
on Jun 03, 2008
Window Off Track
there should be a couple of screws behind some plugs in the door handle (the one you pull to close the door) also if it hasnt got power windows theres a metal clip at the base of the winder small flat screw driver to pop it off also remove plastic inside top off door trim near mirror also inside door lock then try lifting upwards
6/3/2008 3:05:21 AM •
1995 Audi A6
•
Answered
on Jun 03, 2008
03 a6 quatro that started slipping,fixed a broke line,now leaking oil out hole in the bell housing below torque converter and had a code for torque switch stuck off...
what was slipping , not told clutch. ? no M/t box here.
brakes dead? no.
automatic with TC , sure.
so fluid leaks there are 1 of 3 kinds !
engine oil (shades of brown)??
ATF red fluid/????
or green antifreeze leaking from say rear freeze/core plug or from intake manifold leaks. coolant or water core heator core leaks
or any water hoses leak. I run Prestone and is GREEN today.
asking the blind to find leaks is OVERTHETOP.
TCC errors, most are bad solenoid inside the box.
TC clutch lockup sol.
i bet you mean the A/T box slips in all gears?, PRNDL R, D and L>
or only higher gears in drive slips, called FLARE or False neutrals
causes are huge. for slip
20 year old box.
no miles told on Odometer. dash
250,000 miles>?
fluid too low sure is if leaking out. (TC seals or pump seals)
fluid smells burnt or looks like tar on tip of A/t dipstick
a/T Filter clogged.
25 seals inside box leak inside and add up to PUMP overload.
bad pump a/t or its regulator
bad clutch packs in the box or its slave servo bad.
bad shift solenoids , or TCM bad.
shifter linkage bad, or cable if is that. or not adjusted by the book
some cars only reverse works others, only reverse fails
huge list of failures symptoms on any A/t box. not told you.
2009 Audi A6 3.2. Crank but no start OBD2 shows misfire on cylinder 5.
Erasing the codes doesn't fix the problem. You will need to find out what is causing the misfire. What EXACTLY is it doing when you crank it? Does nothing? Just turns really slowly? Turns at regular speed and nothing else? Turns, tries but won't idle? Comment below and I'll see what help I can give you.
Audi 2.4 v6 coolant leak from behind engine bay,
no, just seals, get under it and see where it's coming from, some models have hoses back there, go to place with lift and ask them if they can put it on lift to see where leak is coming from, or use car ramps "$50.00" new and drive up on them and see for your self...
Not finding what you are looking for?