20 Most Recent 2005 Honda Pilot - Page 5 Questions & Answers

its just 2 parts. a cable and a sheath. the cable inside is broken the sheath must be clamped down or moves and defeats the whole propose. the other end is not moving,,,,,, mechanics... its siezed.

call your honda dealer

its called the defrost heater element. no wire, no heat.it has a connector on the windows. if the terminal is brokenhave a skilled mechanic fix it, some can not, short of a new windows. (there are repair kits sold)im blind as a bat (no photos) but that ts my best guess.

EGR struck open.compression low and 1 or more cylinders.ISC parts sticking,id CEL lamp out driving or idlingno, scan it.if in canada, scan it 1 more time.

rock and hard placeyou only have a few choices,1: DIY2: sell it3: scrap it. (sell each part on fleabay and be rich)4: or let honda fix it.it is your choice, if this is a DIY question and not a GUESS game.then, read the FSM. read the pages on air bagsits all clear, what to do .... every step.this is true for all cars. ill post rule 1 now.never work on bags (touch parts or related wires)until you do the FSM bag defeat procedure , we have many folks killed or maimed buy not RTM not reading the manual or doing the steps stated so clearly.It can snap a persons neck or your helpers. easy. in range of bag.drive to honda, at the parts window say FSM for Pilot.bingo. the factory service manual.the roadworth guys are well trained and fooling them is not going to happen. cost varies by what is bad, and who fixes it and if new or used parts are installed, and city you are in, costs vary by city .and whats expensive to you, may be pocket change to others.nobody knows this.here.you must fix it or sell it.in some places in uSA, you cant even sell it, "calif'.

Undo the center nut and loosen off the tensioner so that you can remove the pulley of the shaft. Replace with a new pulley as it will be cheaper to do that unless you have the technology to replace the bearing in the pulley

Vehicle Stability Assist (VSA ) with traction control (standard on all models starting in 2012) enhances handling stability and predictability especially in poor ...read the op guide? (hint, in glove box)pull its fuses and pray.scan tool reset? if DTCs set.read the FSM under VSA?or go to alldata.com

Pass anger bearing?

2005 HONDA PILOT - V6 3.5L 3471cc GAS FI N J35A6

Belt Routing Diagram Multiple Accesorie



More details: DAYCO Catalog

I hope help you (remember rated this help) Good luck.

no you got it right just make sure it isnt tranmission fluid when it comes out. hondas are tight you gotta bust your nuckles up a bit. or try buying a long pair of needle nose pliers to get to it