20 Most Recent 1993 Volvo 960 Questions & Answers

You probably need to get the codes cleared on the ecu before the engine light will go off. Even after you fix the problem, the computer doesn't know that the problem has been solved until the fault codes have been cleared.

BAD RELAY

I think ther are rubber bushings that hold the wiper arms on the wiper linkages that have worn out,some cars have these & if the arms can't move because the blades were frozen to the window,those linkage shafts that the arm fits on were still turning underneath tearing the rubber up,can you here the motor turning with no wiper movement,or is there nothing,could be blown fuse cause the wiper motor got hot from not being able to rotate inside?

sounds like acrank position sensor it will keep vehicle from start if going bad

under the hood in box on drivers side ,should have removeable cover ...should be the place?? good luck.

Hi there? service lights normally are there to tell you that the car is due for a service.

a faulty injector a dirty fuel filter a loose wire to ecm

Zoom 1997 Volvo 960 Crankshaft Position Sensor Beck Arnley BECK ARNLEY ENGINE CRANKSHAFT POSITION SENSOR -- A high quality, direct fit OE replacement engine crankshaft position sensor. Condition: New FITS (ENGINE/CHASSIS) SKU PRICE QTY 1997 Volvo 960 BEC1800432 $49.85

1997: All Submodels; All Engines; is this what your looking for 1-800-262-0795

Follow the upper hose on radiator going to engine and you will see it goes to like elbow just remove screw and from housing and you will see thermostat under it!

I think what you mean, is the cylinder head in-take or exhaust valve's are bent, yes, you need to have the cylinder head mill, after the bent valve's are replace, and a new head gasket installed.Hope this was very helpful.

engine type(size) please.

theres no relay but the speeds are controled by a resistor,in the heater box,

seal will be on crankshaft pulley
when you remove pulley will be in timing case knock out and refit new one making sure same as old one and refitted the same way

hi, have it replaced by a good mechanic to get your car back to running, its gonna be a lot of work.

Every car after 87 Should have a high mount stop light. I believe it's on the bottom part of the hatch glass.