Top 20
2005 Chrysler Sebring Conv Questions & Answers
My car is stuttering when
Try changing your fuel filter and check fuel pressure.If you have a check engine lite on check that.
How do I change the alternator on 2005 sebring
Will most vehicles, the alternator is located near the top with a belt going directly to it. This makes removal easier as you only need open the hood (bonnet) for access. Disconnect the battery's negative terminal first, and then disconnect the alternator's electrical connector. Loosen the belt tensioning bolt (also serves to affix the alternator) and tap it with a hammer to get it free to move to remove the tension from the belt. Unscrew the bolt completely and the alternator will be off. If you don't have the new alternator with you, put the bolt back in the mounting hole and snug it up so you won' misplace it. Buy a new alternator belt and inspect the starter belt while you at it. It is easier to change both at the same time, but the starter requires you get under the car to loose it from belt tension.
WHAT DOES THE CODE P2089 MEAN OR WHAT TO CHECK
- Camshaft position control wiring harness connector is damaged or open Camshaft adjustment valve has failed
- Circuit is open or grounded
- Assembly is damaged or it has failed (an open circuit)
- DME power supply relay has failed
My 2005 Sebring 2.7 v6 won't start. It acts like a bad ground, any clues?
Wiring CAN be a problem, but it is not the first thing to check. When cars fail to start but you hear "something" (click), the first thing I suspect is the battery. You say the battery is "good", but you don't say how you determined this. Simply the fact that accessories work doesn't give the battery a clean bill of health. The normal accessory load for a battery is less than 50 amps. It can take more than 200 to crank the engine, especially on very hot or very cold days. Since you only get a "click", and yet the trip computer dims out, this indicates to me that the battery is working very hard but is not achieving enough power to start the car. Do this: get a voltmeter and check the battery voltage at the battery terminals. Do this with the ignition off. A fully charged, good battery will be at least 12 volts. Most batteries have 8 cells in them, each produces about 1.5V electricity. If you are reading, say, 10.5 volts, you most likely have a dead cell in the battery. This will not affect accessories, but will have extreme affect on starting, as the available current is reduced exponentially. Jump boxes are great, but if the battery is dead enough, the box will be working harder on the battery than on the starter and you will get the same results. I've had situations where a battery was so bad that hooking a running car to it for jump a start stalled the running car! If your battery is more than 3 years old, this is the first thing to suspect....but a dead cell can happen to a battery of any age. Vibrations cause the internal plates to break loose and cause dead cells.
Sebring trunk
Remove the back seat and will have a few small access holes to the trunk. You can try to hook them from there.
How do I relieve tenstion on 2005 Sebring belt tensioner?
Find the appropriate socket for the bolt along the tensioner pulley and attach it to the 3/8-inch ratchet handle. Place the socket head over the bolt on the tensioner pulley and push it in the direction indicated on the configuration chart on the hood of the vehicle to loosen the tension on the serpentine belt. Take the flat-head screwdriver to remove the serpentine belt from the tensioner pulley.
Not finding what you are looking for?
