20 Most Recent 2001 Chrysler Sebring - Page 3 Questions & Answers

Some cars have an ignition module with two sections; one for low RPMs and one for High RPMs. You could also have a clogged exhaust Cat Converter or muffler, or possibly a bad coil supplying weak spark or bad plug wires, or even bad fuel filter/regulator/pump.

Hi John, Im AL the owner of Big As Auto Repair! The most likely cause for the wipers not working on high speed would be the wiper switch itself. BUT, other things can cause this issue as well. The high speed in the motor can be bad. Hope this helps and if you should find the time please visit my auto repair website here: http://www.bigasautorepair.com/

Any codes?Did changed an air filter? Dirty throttle body.

I think you might have a sensor gone bad, I really don't think it's the fuel pump. Is there any check engine lights on? If there is put in a scanner or go somewhere where they can scan it. Your your air intake sensor might be faulty.

wit the cable 4 the starter dude

Please don't forget to rate:



Crankshaft and camshaft alignment marks—2.4L (VIN X) Engine


Camshaft and crankshaft alignment marks—Chrysler 2.5L (VIN N) engine


Timing belt engine sprocket timing—2.5L (VIN H) engine

No it will not fit.

Hi you need to check for fuel pressure and volume then injector pulse . check for spark , check timing and compression. If you dont find injector pulse or spark , suspect your cam and crank shaft position sensor. Hope this helps a bit , kind regards Faldih Higgins

What the last guy post is correct, but you have to tel your car what kinda remote you have. Assuming you have homelink Which 95 percent of the cars do ill give you a very short version on how to do this. First thing you need to do is clear the code in your car from any other owners. Do do this turn your car's key to the on or acc non running position. Press and hold the first and last button. Untill the light reacts different ether starts flashing or flashes faster etc. Then you need to get one of your remotes. Press and hold the button you want to set in your car and press your remote button at the same time untill the light reacts diferent. Mind you hold your garage remote as close to your car remote as you can. Then finally Find your learn button on your garage door opener it's self it can be in the back or the front if its in the front you have to remove the cover press the button once DO NOT HOLD IT. then go to your car and press the button you set for about 2 seconds and repet 1-2 more times untill your garage door moves. Make sure nothing is in the way of the garage door. (I know that should go with out saying.)

unless you have had the fault codes read , then you have wasted your money with a tune up Take it to an accredited service centre and have the codes read check for a faulty cat converter blocking the exhaust

check the glove box and trunk..most time the are the route to all evil..lol.. you can see the lights because the box is closed and trunk is as well.. i hope this helps you..keith...

Here's a link to your cv joint removal guide. SAVE 20 GET BONUS 10 GIFT CARD ON ONLINE SHIP TO HOME ORDERS OF 100 OR MORE

did you remove the fault code disconnect the battery and that will take out the code

the front wheels have an upper and lower balljoint . remove the wheel to acsess. or rephrase your question.

Have someone push button at the same time pull top of window up. Or rake door panel off and reach inside door and push bottom of window up while pushing button

the remote battery is probably dead as well

Chrysler Sebring Instrument Cluster Removal Procedure by Cluster Fix Chrysler Instrument Cluster Repair about 50 bucks at a junk yard