20 Most Recent
2001 Chrysler Concorde - Page 9 Questions & Answers
My will not start unless
Change the battery, your battery gone bad, and isn't fully recharging itself, and isn't havn't the min cranking amp require by your car to startup the engine, however there still enought charge in there only to power windows, radio etc. When starting a engine, you need at least a min cranking amp, and requires more when it's cold outside.
I was on the highway
before you go dropping the thank, make sure you are getting volyage to the pump, and fuel to the rail
Battery Removal
Battery is located on the drivers side behind the headlight. You have to jack the car up and remove the plastic cover in front of the drivers side wheel. You can get to it if you turn the wheel tightlly to the left without taking the wheel off.
Procedure for front wheel bearing (hub assembly)
jack up vehicle wheel in question and install jack stand.remove wheel. Unbolt 2 caliper bracket bolts and pry caliper assembly up off brake rotor and hang off to the side with bungee.remove rotor . remove large axle nut. From the back of the hub remove hub bolts most commonly 15mm.Using a slide hammer style wheel puller the hub can be removed. if all you have is a big hammer hit the hub back and forth side to side until it can be removed. Bolt in new hub assembly and torque bolts.Install axle nut and torque. install rotor and caliper. reinstall wheel and torque.
WHAT KIND OF OIL FOR 2001 chrysler CONCORDE?
Hello,
The manufacture suggests SAE 5W-30 oil. Either petroleum based or sythetic. With this age of vehicle I would reccomend petro-based oil. If it has'nt had any oil leaks in the past syntehic would be fine. I choose to use a good quality oil such as, Castrol brand.
2001check engine light came on 2001 chrysler
Yes, you will need to buy a scanner from Autozone, should cost around $60. It will not only allow you to erase the problem and remove check engine light, but you can find out whats wrong and fix the problem. Hope this helps.
How do you replace bulb
Good Evening, I am assuming you are wondering how to replace a headlamp bulb? If you read the owners manual it says to remove the front bumper cover, which is one way to do it. The other way is to remove the upper bar across the front and you can reach the bulbs that way as well. FYI there are less bolts to take off the front cover which is probably why they recommend going about it that way. Hope this helps.
Locked keys in car
prise apart the top of the door from the frame and ask a mate to fish out the keys with a wire coathangar.after bending the doorframe,put a wooden block 1/2 way down the door with the window down and push hard to bend the door back into shape..(this is the easy way NO DAMAGE.)UNLESS YOU HAVE A SPARE SET OF KEYS INDOORS..........wrap a long screwdriver with a towel so you dont mark the paint..
There is a rattling noise coming from my drivers
Hard to tell without hearing it.
But you could have a pebble behind a wheel cover.
The wheel bearing could be going bad, but then you would also have some vibration through steering and brake.
The CV joint could be bad, but that would be worst on tight turns.
Is this only while driving it, or if you jack it up and spin the tire?
Does it feel loose when jacked up?
Is it hotter than normal?
Not finding what you are looking for?