Top 20
1999 Chrysler Cirrus Questions & Answers
A couple months ago, my car overheated on the way
I would tend to think it was the head gasket, but it could be almost any of the gaskets / seals within the engine. If you get oil and water mixing within the engine , found by iol turning gloopy white I would be more sure about the head gasket. I did not think that head gasket replacement was really expensive, certainly less than valve covers.. Sorry can't be more helpful without seeing it and that is not possible.
1999 2.4l. Why don't turn signals and hazards flash?
Hi Shauna, do you know where to look for your hazard flasher relay ? If you still have the vehicles Owners Manuel it will be in there, If not you will need to find the Fuse panel under dash, There in the fuse panel will be a round, silver or even square object coming out of the fuse panel, It will have two prongs sticking out of when you pull it out, That is the Turn Signal/Hazard flasher relay, There also my be two of them in Fuse Panel. pull both out and replace there not very expensive.Hope this Helps, Good Luck Randy. I’m happy to assist further over the phone at
https://www.6ya.com/expert/randall_d932ef6e01588b0f
How do I get the wiper arm off of a 1999 Chrysler cirrus? I've removed the nuts but they still are not budging.
If you have removed the retainer nuts, it will come off. The wiper arms slide on to a splined shaft (so they won't slip when operated) and the often get corroded on (you may see a "whitish" powder around the spline. There are several things to try.
1.) Just grab and wiggle it as you gently pull.
2.) pry it up gently with a tool like a screw driver while wiggling and pulling (be careful - the glass windshield is not far away.)
3.) put a few drops of penetrating oil on the exposed spline where you removed the retaining nut and let it soak for 30 minutes, then start over with number one.
When it does break free, be ready as it may pop off rather emphatically.
You can avoid this next time if you put a very fine coat of anti-sieze grease on the splines before you re-assemble it.
They do come off - really :-)
Why do my automatic locks keep locking and unlocking, even when I'm not driving my car?
Well-- no mechanic or us here, will guess at any vehicle issues
It simply is not possible
Since they just worked on it ,take it back
Could be you had two issues
So do not assume they caused the second one,
at least give them a chance to find the problem
That is why the auto industry has a bad name & is
disliked for 50 years,because you have to be there
& build a relationship & understand their issues in
trying to help your car (not you) your car
Where is fuel filter on 1999 Chrysler cirrus
the filter is located on top of the fuel tank. you will have to lower the tank to replace it. if your changing it due to a running symptom then you should check the fuel pressure and volume with a gage. as this can cause a running problem.
Not finding what you are looking for?