Top 20 1998 Chrysler Sebring Questions & Answers

https://www.amsoil.com/lookup/auto-and-light-truck/1998/chrysler/sebring-convertible/2-5l-6-cyl-engine-code-h-eeb-h/

They are all in here.

Fuse Box Diagram Chrysler

Fuse-Box.info https://fuse-box.info > Home > Chrysler Fuse box diagrams (location and assignment of electrical fuses and relays) Chrysler Cirrus (1994, 1995, 1996, 1997, 1998, 1999, 2000). ..

It's probably history. Look to buy a good used car not quite as old.

indicates problem ignition switch, bad ground for the battery You did not mention make and model but if GM product they have a 12 year ongoing recall for ignition switches

Throttle position sensor possibly

check the cable at ecm if it is pulled to tight up or down this will put stress on the pins and result in a car that runs like it needs a tuneup

It could be a powersteering leak. Sometimes there is a shaft seal under the steering column inside that needs to be greased because f squeaks. The brake problem is from warped rotors, most likely the front since you feel it in the steering wheel.

Could be lots of things but it could be a bad motor mount. Have someone observe the engine when you first start the car and accelerate (with foot on brake and them off to the side) while in drive to see if motor is moving off of the motor mount causing unnecessary noises. Could also be a worn pulley or bad water pump. If this is happening at idle you can listen to try to determine where the noise is coming from.

"drive it around more" is the solution. This allows the ECU to "learn" and store the operating conditions for emissions. 100km/ 60 miles is usually enough.

Make sure oil level is correct. Also the dragging caliber is probably the problem.when you put the brakes on hard one of them is probably sticking now.

I had Chrysler I had the problem I believe in quality do not put junk which makes a problem.Good luck.

Check the attached link: http://www.autozone.com/repairinfo/repairguide/repairGuideContent.jsp?pageId=0900c15280089a44

I would have probably given it a total tune-up, first, checked all the fluids. New antifreeze. Changed the oil and filter. Drained the gas tank, used fresh gas. Pulled the spark plugs and belt, put a drop or two of oil in each cylinder, then turned the crank by hand before trying the starter motor. Then, if it cranks good but won't start, have a helper crank it while you visually check for spark at the spark plugs. If spark everywhere, use a gage and check proper fuel pressure. Also, check fuel injector pulse. Any applicable trouble codes?

It is pressed on so you need a gear remover to do it.

You can't. Once it's enabled, it must be serviced at a dealership.

Read the fault codes, check the fuel pressure.

Pick up a Haynes manual for your vehicle, it will provide a complete tear down. You can purchase one off of eBay or Amazon

There was a popular repair done back then that provided smoother shifting and removed that sound it has like a toy winding up. It was a valve of some sort if I recall correctly. But there was no recall & it was only repaired if under warranty and a lot of complaining. I was able to improve my shifting noises substantially by having the trans fluid completely evacuated(not simply drained) refilled and adding Lucas transmission treatment. Hope this helps.

U dear the hood is the starter relay u mist jump it to another power fuse and sort of hot wire the starter but must have the key so the steering is unlocked YouTube will have the video and only you will know how to start it

FLAT SPOT? have the engine checked over, maybe get a compresssion tester and check cylinders are all good and have similar compression? Might be nothing serious but probably needs some thourough investigation as soon as possible.