Top 20
1996 Chrysler Sebring Questions & Answers
96 Sebring stalling out at times
The MAP sensor does the same thing as a TPS Throttle position sensor Tells computer at what angel the intake butterfly is at non fixable Replace the part
My 96 sebring coupe xli wont crank or start how do i check the starter relay
Is the transmission (automatic assumed) in "P"? If manual, are you holding the clutch pedal down?
Do you have functioning headlights? Does the starter TRY to crank the engine but not have enough power to do it? If so, check all your ground connections. Is the battery discharged or fully charged?
Put a voltmeter on the battery and have someone try to start the car. Watch the battery voltage when they turn the key - it should NOT drop below 9V. If it does, it's discharged or internally damaged.
It may be a pure coincidence - all batteries get to a certain point after which they can't be used any more. You may have just lost one cell in the battery. Or... when you changed the water pump, you may have disturbed something you shouldn't have disturbed.
I drive my car every day and I think the overdrive not work becouse when I drove 60 miles the tranny sungs like forse
my transmission would stay in first gear , if this is the problem get a control soleniod sensor from junk yard i did it worked fine. first get a haynes sebring repair book: it is located on top of trans on driver side, you cannot see it, remove accelerator cable and cruise control cable, two screw holding metal pipe on manifold wire fitting on soleniod, then bolt holding it twist and pull gently it will slide out. BUT FIRST, PRACTICE ON A SEBRING AT JUNK YARD. it was easy but it took time a very tight fit, i saved $300 i hope this helps
Will not go
If the engine is running and the car won't go, it is a problem in the drive train; clutch, transmission, driveline(s). Smoke out the oil fill (a small amount) is normal.
Not finding what you are looking for?