20 Most Recent 2005 Cadillac SRX - Page 7 Questions & Answers

Check Ebay for these. There are several out ther and some people make these very affordable and even add more information than is supplied by the manufacture. There are several out there and I chust checked so they are available. There is a wide range in prices but if you start to search more generally come up and then you can decide on what you want to spend. All these manuals have good information for do it your self repairs

Gday mate, geoff here, ussually instructions to that will be in the drivers manual in the glove compartment, most system use the radio to reset it.

Three things come to mind. A heat shield is loose, The inside of the converter is going bad or you ran over a reindeer!

sounds like a bad converter. take a mallet and hit exhaust from front to rear until you find the rattle.

Hello and welcome to FixYa!

As a first course of action, I strongly suggest that you remove the positive battery connector and let it sit for at least 5mins. before reconnecting it. This will reset the system and can get your vehicle back to it's normal operation.

Hope this helps and thank you for using FixYa! Have a good one!

It sounds like a problem in the driver's master window control switch. That is where all the wiring comes together.The door and window gets controlled by same switch.If the switch is getting shorted then this problem occurs.The switch has connections in it, if particular connections gets short, then it will stop functioning few functions, but other doors windows will operate.--------- This will help.Thanks.Helpmech.

Check Lights are OBD2 System Malfunctions,
that have been with us for 30 years,nothing to
do with oil.

You most likely have cylinder misfires, that need
to be diagnosed,or one of ten other possibles

• Hi, I can help.

1. Turn off all electronics in the car.
2. First you want to remove the negative and positive cables on the side of the battery.
3. You will notice on the sides of the battery box ( towards the bottom lip of the lid ) there are bolts on both sides that secure it.
4. Remove them bolts.
5. Now there is this harness on top of the box that is kind of in the way. If memory serve it is kind of connected by a little plastic connector. Take a Flathead screwdriver and lift up underneath the plastic piece just until it pops loose from the cover.
6. Now the lid comes up and you have to maneuver it around the harness. It's kind of a tight fit but not to bad.
7. Install a new battery

• If you have any comments please feel free to leave them here.
• Hope this helps and thank you for using FixYa.

Regards, Tony