20 Most Recent
1993 Plymouth Voyager - Page 4 Questions & Answers
Changed coil did not help
The coil or distributer is probaby shot,Or the control module, Or the relucter, In the distributer,
Hazard warning light don't work
Its possibe that ypou have independient FLASHER device, one for hazard and one for turn signal; check backside of fuse panel and replace it.
Does my 1993 6 cylinder 3.0 Plymouth Voyager have
Hello tunamae: My name is Roger and I will help. Your 1993 Voyager has struts on the front of the vehicle. In order to change them you will need special strut tool in order to change the strut springs form the old struts to the new ones. Should you need further help please just ask.Please rate the answer you received as this way I know it was helpful. Thank You for using Fix Ya, Roger
2.5 liter Engine Replacing Alternator Belt
loosen the bolts on the alternator let it slide forward put the new belt on. use a pry bar to hold the alternator as far back making the belt as tight as possible and hold it there while you re-tighten the bolts
How do you adjust the rear wheel bearing?
Rear wheel bearings on front wheel drive vans are much like front wheel bearings before front wheel drive.You have an inner and outer bearing with a nut and lock washer.After the bearings are packed with grease, you tighten down the axle nut until snug then back it off a notch. Then put the lock washer or lock ring on. Some have a cotter pin to hold the nut in place.The wheel should spin with no drag from the bearings.
DEX/MERC okay for 1992 Plymouth Voyager?
I would not use it unless your owners manual specifys Dexron. I know on the Gen. 1 Voyagers ie.1984 to 1990 They required Mopar ATF+3 or transmission damage and failure was common if DEXRON was used.
Not finding what you are looking for?