20 Most Recent 1995 Jeep Cherokee - Page 6 Questions & Answers

A bad ecu, in need of repair, will also cause a no start condition in your Jeep. Search on this site for "delayed start no check engine light problem'.

blown fuse

You have to take it to a dealership. They have a computer that programs stuff like that. It usally costs $20 and only takes them 5 minutes.

You should activade the OD on your Cherokee if your are hauling a trailer. or if you are in a constant climb.. The OD activated will maintain the transmission in third gear.

Sounds to me like your jeep has what's known as the delayed start check engine light problem. Check to see if your check engine light comes on, when you turn on the ignition, at the times when the fuel pump is 'delayed'. If no check engine light comes on then your ecu needs to be repaired or replaced. Both options are available on ebay. The jeep will not start until that check engine light finally coming on.

sounds like windsheild leaks around the seal

That's all that's really left is evaporate cannistor I would have done that first

HI there:For the engine computer, the connector is in the engine compartment, right beside the coolant overflow bottle. It should be clipped to the wiring harness, and may have a plastic cap on it. It's shaped like a fat L.Extracting Fault Codes:Without ever starting the engine Turn the ignition switch ON, OFF, ON, OFF, ON and observe the CHECK ENGINE LIGHT. The CHECK ENGINE LIGHT should begin to flash a series of codes. The flashes will be separated by short and long pauses. The long pauses separate the "ones" and "tens" positions, and each code from the next. A code 55 will be displayed at the end of the test.Hope this helps.

I had the same thing happen to me.The piece you found is dealer part # 56001110 and is a 4.8 amp breaker that controls the windshield wipers.It plugs into the bottom of the fuse panel, a little above where your left foot rests when driving the car.I was wearing my size 14 boots and kicked it out, which snapped off the two tabs.I pulled the tabs out of the box with pliers then bought a replacement.I read that the dealer sells them for about $30 and some websites (like Quadratec, part # 17015.8000) sell them for about $30 as well, but I bought one on eBay for a few bucks cheaper.That fuse panel is in a bad location.

button may need replacing

possible causes of overheating are, dirty cooling system, clogged radiator, bad thermostat. Use only distilled water with a good quality coolant.

still overheating? have your top head checked - warped head, valves, valve seats, etc. You might need to have your engine's compression checked if it is still within specs.

Clutch pedal switch is bad. It's located behind the clutch pedal. The Jeep may accidentally start in gear and lurch forward, injuring someone. Replace the switch, for safety.

take battery leads off clean posts and replace. If knowthing happens your battery may be dead. If clicking sound then its your starter motor. Tap it with a hammer and it may start. Try jump starting it from another car. Or ring the NRMA.

On Chrysler products, you check the ASD relay for power and then the coil for power and a ground pulse from the distributor. I am assuming you do not have spark at the coil and at the plugs and this is the 4.0 engine with a distributor.

right side dash open your right driver door and look at right side of the dash.

FAN SHOULD NOT BE LOOSE OR WOBBLY IF CLUTCH FAN BOLTS ARE TIGHT, MORE LIKELY FAN CLUTCH IS BAD NEED REPLACING.