20 Most Recent
1994 Isuzu Amigo Questions & Answers
Reverse
Check the level fluids, maybe is in low level.
Isuzu mu
It is not adjustable as it is Hydrolic. it self adjusts.
If you just installed a master cylinder for it, the shaft does have a minor adjustment on it.
Most likely what is happening is one of two........
1. The clutch is worn out and the pedal is getting VERY LOW.
2. The clutch is new and you have air in the system............. These things are a nightmare to bleed out. slowly pump the pedal while someone uses a prybar to disengage the clutch to allow full travel of the slave cylender. While they hold the pedal release the pry bar and open the bleeder, repeat twice more, then fill the master cylender again, continue until all air is out!
Engine won't start
Try tappung on the starter while someone trys to crank it prolly bad srartet
Clicks when trying to start
pull the starer motor and have it bench tested . It may be the solenoid is not making good contact inside or there may be a problem with the armature.
Idle
If you have a viscous fan hub have it replaced as it is not working properly. If you have electric fans have the fault codes read
Clutch not letting me shift
The clutch came new with about 10 years of service life if it was used gently. You are at 16 years. Most likely time for a new clutch. Adding fluid to the clutch's hydraulic actuator system is not going to add new life to the clutch.
Not finding what you are looking for?