my 2002 isuzu rodeo transmission is slipping should i first get it flushed before buying a transmission?
Posted by princessno... on
I have a 2002 Rodeo and just had the transmission leak fixed, but my truck is jumping and jerking and seems like it is stuck in gear. I don't see anything leaking and tired of taking it to the dealer so what could be my problem.
Posted on Apr 11, 2010
diagram for serpentine belt on 2002 isuzu rodeo
Posted by drewhiggs1 on
Assuming you have the V6 3.2L engine (no diagram available for the L4 motor), the diagram is below. Thanks for using Fixya!
Posted on Feb 25, 2011
what is the firing order for isuzu rodeo 2002 2.2 lits
Posted by gaband29 on
Please don't forget to rate! This helps us help you!!! Thanks!! 2.2L VIN D engine Firing order: 1-3-4-2 Distributorless ignition system
2.2L VIN D engine Firing order: 1-3-4-2 Distributorless ignition system
Posted on May 12, 2011
diagnostic code for isuzu rodeo p1125,p1295, and p1550
Posted by jonesie200... on
P1125 is: Throttle Positioning Sensor intermittent.
P1295 is: Multiple faults on bank 1 (right)
P1550 is: Power steering pressure sensor out of self test range.
Well the ECM recognizes 3 codes. Were these codes stored as inactive (in the history section)? Or are these codes all active? Code P1125 and P1295 may be related but P1550 is separate. How else may I help?
Posted on May 06, 2010
Where on the transmission -- is the shift solenoid located on the 2002 Isuzu Rodeo
Posted by barnes7096 on
It is located just under the pan in a block called the valve body, it contains 2 shift solenoids, and a million little canals for oil. There is no drain plug on it, just have to drop the pan and spill out the fluid, that drips for months afterward. You can change these things if you are handy, if not, don't even attempt it. Watch out for the check balls,
Posted on Feb 15, 2010
I am trying to remove the 2 belts in front of my alternator on my 97 Isuzu Rodeo. I am unable to loosen the tension on the 2 belts in front of the alternator. How do I do this? Also is there a site to watch a video on how to do this?
Posted by riderws6 on
You need to loosen the alternator so the belts become slack. Look for bolts on top and bottom that attach the alternator to a bracket or the engine block. Loosen them and the alternator will move. Since the belts hook to other accessories, you may need to loosen them too. To get them back and the proper tension, you'll need a large screwdriver or pry bar to put tension on them as you tighten the bolts. I suggest you get a Haynes guide for this model that will have photos showing how this is done.
Posted on Jan 11, 2009
2002 isuzu rodeo V6 4wd loss of power: When I am ideling with my AC running all of a sudden I loose all power to my eng. The eng is still running, but there is no drive capability.
Posted by noahjoseph... on
2002 isuzu rodeo 2.2 loss of power will go no more then 10 miles per hour
Posted on Sep 20, 2009
2002 isuzu rodeo, won't crank, push starts and runs fine. took out starter and had it tested at store, they said it was good. Tried test light under the hood and there was no problem I could find. Someone suggested it could be the clutch pedal ignition lock switch. Is it also called neutral safety switch and other names? Where is this located and is it easy to change?
Posted by father0811... on
Look under the dash at the clutch pedal. Should be a switch or a button hidden under there near the top of the pedal. Pull the connector off and put a large paper clip in it, or a short piece of wire, and try the starter. If it doesn't work then check the starter fuse and relay. Just swap the starter relay out with something that you know works like the AC or Fuel pump and see if it starts. If all else fails then it could be the ignition switch itself.
Posted on Jul 13, 2009
What is code p1340 a 2002 Isuzu rodeo
Posted by Guest on
1st google hit, ever google?
the Ion Sensing module senses all 6 COP coils.
for weak spark.
you are not getting other DTC errors??? this is key.
1340 means it sees errors. this module. with a real scan tool
you can see all factory codes.
what id do , is the tuneup, why try find out why high voltage
spark is weak , before a tuneup>
spark plugs top list. no lie.
1st google hit and good.
read post 2
google really is your friend, for sure.
finding isuzu books is no fun
so use alldata.com.
Posted on Aug 10, 2014
need to know how to line up the timing marks
Posted by charlesdev... on
you have to have a timing light gun when light is on its like a strobe light and pointed to timing belt it shows the lines that need to be lined up together
Posted on Dec 13, 2012
590 questions posted
Usually answered in minutes!
Step 2: Please assign your manual to a product: