1999 Honda Prelude - Answered Questions & Fixed issues


try replacing the throttle positioning sensor its on the throttle body

1999 Honda... | Answered on Dec 05, 2018 | 458 views


do a leak down test. It's common for early 90's Honda's to have bent valves. a leak down test may confirm it.

1999 Honda... | Answered on May 02, 2017 | 80 views


The system is self bleeding, no bleed port is needed. You can use the fuel pressure test port to bleed it if you want, but just holding the gas pedal to the floor while you crank the engine will bleed the air out very quickly..

1999 Honda... | Answered on Nov 29, 2016 | 47 views


Check your fuses as well to make sure you don'r have a blown one keeping the pump from working. If you find no problem there; drop the tank and re-check all my electrical and hose connections. I'm assuming the pump was a known "good" one.

1999 Honda... | Answered on Feb 20, 2017 | 43 views


There is no bleed screw, the system is self bleeding as you crank it over any trapped air is expelled through the injectors nozzles..

1999 Honda... | Answered on Nov 23, 2016 | 41 views


-Here some basic.
-Turn the key to on and off couple time. (Do not start).
That all.

Good luck

Mai

1999 Honda... | Answered on Nov 23, 2016 | 54 views


The all in one PGM/fuel pump relay is bolted to the upper left hand side of the drivers foot well. It should be gray box with lots of wires coming out of it.

1999 Honda... | Answered on Sep 14, 2016 | 223 views


All the vents in the front dash have adjusting fins in them. to turn in a certain direction and to open or close them. Look at them. If you can't open them with the small knob at the vent. Use a small screw driver or key to open them up.

1999 Honda... | Answered on Jun 18, 2015 | 39 views


If the dash lights are on the same circuit as the park lights. Chances are if no dash lights... no park lights. Unless the dash light dimmer switch is on the low position. Check park light fuse. If no brake lights... which are on a different circuit and you are sure the bulbs are ok check brake light fuse. If fuse ok, unplug brake light switch at brake pedal and cross the terminals with a jumper. If brake lights work, the brake switch is faulty. If still no brake light operation suspect a wiring issue

1999 Honda... | Answered on Jun 18, 2015 | 258 views


IN a car this old, the drain lines in the head for the oil might be plugged up. Check them and replace the valve cover gasket

1999 Honda... | Answered on Dec 03, 2014 | 54 views


Verify fan operation(be carefull not to let the car overheat) and if they dont work try these steps. (If you have electeical know how)
check all fuses
check relays by swapping with another known good relay.
look around with a tester and see where along the circuit you are getting voltage.
replace the
6b70f36d-a432-4040-a5d9-7d3d751d5c8d.jpeg SpoonerTuner com Free downloadable Honda Acura Factory Service Manuals...

1999 Honda... | Answered on Jun 05, 2014 | 168 views


best bet is to get a Chiltons manual to save time and money.

1999 Honda... | Answered on May 26, 2014 | 131 views


Heater motor is under dash passenger side.

1999 Honda... | Answered on May 23, 2014 | 80 views


P0758 Problem in Shift Solenoid Valve B Circuit
Fault :
Solenoid Valve 2 B - Open or Short to Earth or B+
Cause:
Wiring/Connectors from/to Solenoid Valve 2 Open or Short to earth.
Solenoid Valve 2 (N89) faulty.
Engine control module (ECM)/Powertrain control module (PCM)/Transmission control module (TCM)

Solutions:
Check/Repair Wiring/Connectors from/to Solenoid Valve 2.
Check/Replace Solenoid Valve 2.

1999 Honda... | Answered on Jan 07, 2014 | 445 views


double posted, back up one post,its there.

1999 Honda... | Answered on Jan 02, 2014 | 53 views


its in the FSM, its non trivial
1999 is, gen5 . read your FSM here, its in the HVAC sections
or at alldata.com

#5 be it. 97-01
http://hondatech.info/downloads/Auto/Manuals/Prelude/

1999 Honda... | Answered on Jan 02, 2014 | 232 views


fuse

if fuse good, bad brake light switch.

1999 Honda... | Answered on Dec 10, 2013 | 22 views


Pull the oil filter off, remove the mounting adapter and replace the "O" ring seal.

1999 Honda... | Answered on Apr 08, 2012 | 353 views


We do not have this diagram. The info is contained in the factory service manual and that is copyrighted and not free to share on the web. Sorry. I am told you can access the info for a small fee here: alldatadiy.com

1999 Honda... | Answered on Apr 08, 2012 | 193 views


run it on d4

1999 Honda... | Answered on Mar 12, 2012 | 265 views

Not finding what you are looking for?
1999 Honda Prelude Logo

Popular Tags

113 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Honda Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...