20 Most Recent 2003 Suzuki Aerio - Page 9 Questions & Answers

First check the code what is then try to fix.Could be speed sensor.

In the tank on the pump. K..?

yes,CRANKSHAFT SENSOR When a crankshaft sensor has failed or is failing, certain timing problems will arise in engine function. The engine may start normally in some cases, but will cut off after a few minutes (or seconds) of operation. More than likely the engine will be unable to start at all. Since the crankshaft sensor is responsible for engine timing, the driver may experience engine backfire or irregular rpm function, if the vehicle starts at all.

Without hearing the squeal, I presume its coming from under the bonnet and only when the clutch is pushed in if so, I would be fairly certain that it is the clutch thrust bearing. To check start the engine, depress the clutch so that the squeal is present. Then whilst it is squealing gently rev the engine, if the squeal varies at at then I would be 99% certain that it is the cause. Unfortunately the only fix for that is replacement of the clutch. hope this helps

i think that can be taken off when you service it .. it stays on for 12 month or when you switch it off by one of those gadgets the have at the garage ... as far as im aware.

Here is a possibility for your problem. If this is an automatic trans.the trans. is staying engaged stalling the engine. If this is the case a fluid change will not fix this issue, it is internal in transmission.Good luck.

did you change the fuse? may need a new blower?

If your engine won't reach 2000 rpm's and it has no power, check everything you can and then replace the catalytic converter. I was skeptical but it sure ran like new after that. They get clogged and create back-pressure.

Why would you ask again?You know enough to go to a trans shopNow you don't like the advice you got,so you want us to guess for you TCC Solenoid?What was the problem--- Torque Converter Chatter?There is a product for thatIf you change the fluid it might help

I will check the exhaust sensor, with todays gas you may have to replaced that could be the problem.