20 Most Recent 2000 Lexus ES 300 Questions & Answers

The ES300 doesn't have HID lamps unless it was a later addition. It takes standard 9005 halogen lights. https://www.lightbulbs.com/automotive/2000-lexus-es300-replacement-light-bulbs ..

I will help you I have been there before what you're going to have to do is program the key for the entire car and you can do that by following instructions on YouTube or you can call the dealership and I'll give you instructions for free

if the vehicle was not designed for hids its best to make a relay system off the original head light wiring, like you would do for fog/spotlights this would draw power direct from the battery and not the original wiring as the original wiring may not be able to take the drain from the startup of the hids. there are kits for vehicles so no wire cutting is involved, just plugs into the original wiring. same with led kits. https://www.hidextra.com/lexus-es300-hid-kits/

check the main earth or negative ground between the engine in the chassi..hope it work

Yes the airflow meter is very easy, it is in the air intake hose to the engine from the air cleaner. Boy those Japanese car makers really take you to the cleaners on repairs, that repair on a GM car would have been 1/2 that amount.

the bolt goes through the both flanges and the springs go against the last flange and under the nut of the bolt it is a system that allows movement between the couplings so that the system doesn't crack from fatigue due to engine/ , pipe movement

Hi, have a good look on web, I was told similar over the top cost for ford focus, looked at web, and on that vehicle, insert key, turn on (till ign lights show, DO NOT START, turn back one click, then back to ign lights show AGAIN NOT STATRING, on board computer reprograms key. That worked for me.

they are bolted together & rust & auto repair are enemies. It may very well be possible. u can get a 2nd opinion if u want.

Airflow meter butterfly covered in carbon and oil remove and clean with carbon cleaner

Insufficient Coolant Temperature for Closed Loop Fuel Control http://www.autocodes.com/p0125_lexus.html

Drain oil from the oil pan and recycle. Remove bolts holding oil pan up and remove oil pan. Remove bolt holding oil pump in. Install new pump. Replace oil pan gasket if necessary. Reinstall oil pan. Reinstall drain plug and refill with oil. Start engine and watch oil pressure gauge or light. Oil pressure should be normal almost instantly. Check for oil leaks.

There may be a parking brake adjuster, loosen it off, see if it helps? Next, get at the rear brake assembly, if there is a star adjuster loosen it off, hopefully, that will loosen the brake pads? At the rear brake assembly, maybe you can get at the parking brake cable? I can't see anything from here. Safety is your responsibility, if you get brakes released, you need to make sure brakes work properly before driving, again.