2000 Chrysler Town & Country - Answered Questions & Fixed issues


Try rotating the steering wheel; it may be inline with one of the locks.

2000 Chrysler... | Answered on Jan 20, 2018 | 86 views


have a load test done on the battery
have the charging system properly checked by an auto electrician

2000 Chrysler... | Answered on Dec 20, 2017 | 60 views


have you disconnected the wire to the clutch coil
if you have and it is still not free wheeling you have a bearing failure in the pulley on the compressor shaft

2000 Chrysler... | Answered on Dec 11, 2017 | 126 views


Sounds like more than one issue. 17 year old Chrysler, so it is not a surprise. Blend door actuator, HVAC power head are possibilities. If this is still powered by vacuum lines, they could have leaks at this age and nothing will work right. This all could require dash removal of various degrees to test and repair.

2000 Chrysler... | Answered on Nov 30, 2017 | 139 views


Check for wiring that moves when you turn the wheel. The harness may be tangled in the steering linkage. This could be under the car or under the dash by the steering column. It could even be the ignition switch wiring.

2000 Chrysler... | Answered on Nov 08, 2017 | 32 views


I had a similar issue where the hose to the front washer nozzles was broken. I fixed the break in the line and the washer worked without issue.

2000 Chrysler... | Answered on Aug 27, 2017 | 91 views


You have a MASSIVE engine vacuum leak.

2000 Chrysler... | Answered on Jul 20, 2017 | 27 views


car repair sit will be better if go to http://toolsnyou.com/ for your car repair as i also visited lot of service center but at last i got mu solution on the above site

2000 Chrysler... | Answered on Jul 02, 2017 | 79 views


Check the oil level. The low oil sensor will disable the ignition if more than a quart low. If you have not checked your oil in the last 1600 miles, its past time to do so. Check oil often.

2000 Chrysler... | Answered on May 27, 2017 | 87 views


people like Ariana new help their help who with their and tooo sorry happen just so now 5012731103

2000 Chrysler... | Answered on May 24, 2017 | 83 views


Obviously, you are talking about your vintage 1932 Chevy Coupe. I know that's the vehicle because you did NOT say that it WASN'T!

The fluttering sound is probably dry leaves that got stuck in the blower assembly! Suck them out with a shop vac!

2000 Chrysler... | Answered on Apr 29, 2017 | 84 views


Dot 3 should be fine. Most cars use this.

2000 Chrysler... | Answered on Jan 16, 2017 | 187 views


In the junction block, check 10A FUSE 8 and operation of the NAME BRAND SPEAKER RELAY

2000 Chrysler... | Answered on Jan 15, 2017 | 29 views


Use a gage and check proper fuel pressure. Cycling the key on and off several times before you crank it, allows the fuel pump to prime the system.
How long since a tune-up? Are there any applicable trouble codes?

2000 Chrysler... | Answered on Jun 09, 2016 | 58 views


sometimes you might have to thump the hood at the front . they do stick occasionally

2000 Chrysler... | Answered on Apr 05, 2016 | 260 views


The Internet, though, has a large number of web sites where you can buy service manuals and schematics from bookstores, publishers, and other collectors. Here is just a sampling of what sites are out there:

Chilton Repair Manuals
http://www.chilton.cengage.com/

Factory Automanuals
http://www.factoryautomanuals.com/
web based auto repair manuals

Haynes Publishing
http://www.haynes.com/

Vintage Books
http://www.vintage-books.com/

AutoLit.com
http://www.autolit.com/home.htm

RepairManual.com
http://www.repairmanual.com/

2000 Chrysler... | Answered on Feb 05, 2016 | 177 views


The Internet, though, has a large number of web sites where you can buy service manuals and schematics from bookstores, publishers, and other collectors. Here is just a sampling of what sites are out there:

Chilton Repair Manuals
http://www.chilton.cengage.com/

Factory Automanuals
http://www.factoryautomanuals.com/
web based auto repair manuals

Haynes Publishing
http://www.haynes.com/

Vintage Books
http://www.vintage-books.com/

AutoLit.com
http://www.autolit.com/home.htm

RepairManual.com
http://www.repairmanual.com/

2000 Chrysler... | Answered on Feb 05, 2016 | 166 views


if there is a relay in the starter circuit, that is suspect
I would remove the starter motor and check 2 things
first is the condition of the teeth on the ring gear
they have a habit of burring over and the pinion gear gets stuck and will not disengage
next is to check is the pinion teeth the right number on the new starter for the ring gear
That is sometimes an issue but I would suspect first a relay , next damaged teeth on the ring gear ( they appear at specific places on the ring gear (90 degrees -120degres and 180 degrees and run for around 6 teeth where the starter initially engages the ring gear
the smoking is from a burnt out starter because when it is stuck in the ring gear , the starter becomes a generator with uncontrolled current generated going straight to ground

2000 Chrysler... | Answered on Oct 20, 2015 | 124 views

Not finding what you are looking for?
2000 Chrysler Town & Country Logo

764 questions posted

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...